Difference between revisions of "00810"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m (New page: __FORCETOC__ == 00810 - Sensor 1/2 for Brake Pressure == === 00810 - Sensor 1/2 for Brake Pressure: No or Incorrect Basic Setting / Adaptation === ==== Possible Symptoms ==== * Malfunct...) |
RtWiKiSyS0p (talk | contribs) m |
||
| (One intermediate revision by the same user not shown) | |||
| Line 10: | Line 10: | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
| − | * Basic Setting not performed | + | * Sensor 1/2 for Brake Pressure Basic Setting lost/not performed |
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
| − | * Perform Basic Setting | + | * Perform Sensor 1/2 for Brake Pressure Basic Setting |
| + | ** See Vehicle specific [[Diagnostic Procedures]] for Details | ||
| + | |||
| + | |||
| + | === 00810 - Sensor 1/2 for Brake Pressure: Implausible Signal === | ||
| + | |||
| + | ==== Possible Symptoms ==== | ||
| + | |||
| + | * Malfunction Indicator Light (MIL) active | ||
| + | |||
| + | ==== Possible Causes ==== | ||
| + | |||
| + | * Sensor 1/2 for Brake Pressure faulty | ||
| + | |||
| + | ==== Possible Solutions ==== | ||
| + | |||
| + | * Check/Replace Sensor 1/2 for Brake Pressure | ||
| + | |||
| + | ==== Special Notes ==== | ||
| + | |||
| + | * In cases where the Sensor for Brake Pressure is part of the Brake Hydraulics Unit, the complete Unit may need to be replaced. | ||
| + | |||
| + | |||
| + | |||
| + | [[Category:Fault Codes]] | ||
Latest revision as of 17:05, 6 June 2008
00810 - Sensor 1/2 for Brake Pressure
00810 - Sensor 1/2 for Brake Pressure: No or Incorrect Basic Setting / Adaptation
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Sensor 1/2 for Brake Pressure Basic Setting lost/not performed
Possible Solutions
- Perform Sensor 1/2 for Brake Pressure Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
00810 - Sensor 1/2 for Brake Pressure: Implausible Signal
Possible Symptoms
- Malfunction Indicator Light (MIL) active
Possible Causes
- Sensor 1/2 for Brake Pressure faulty
Possible Solutions
- Check/Replace Sensor 1/2 for Brake Pressure
Special Notes
- In cases where the Sensor for Brake Pressure is part of the Brake Hydraulics Unit, the complete Unit may need to be replaced.