Difference between revisions of "01044"

Revision as of 10:49, 24 January 2013

When found in CAN-Gateway:
- On a Long Coded module, use the Gateway Installation List to check for unreachable or not registered control modules. Then update the Gateway [Installation List] by altering the Gateway Coding manually.
- On a Short Coded modules, refresh the original coding with the same value. For example, code it from 00006 -to- 00006 without making an actual change.

When found in the Comfort System on the VW New Beetle/Cabriolet (1C/1Y/9C) this may be a bug in the module that will be resolved by refreshing the coding with the same value as described above with the CAN Gateway example.
When found in Brake Electronics (MK60EC1) while the Coding is NOT all Zeros, check the [19-CAN Gateway] > [Coding - 07]. An incorrect LHD/RHD Configuration may cause this Fault Code.

Some Passat (3B/B5) around MY 2000 have a Firmware Bug which causes this DTC to be set in the CAN Gateway (19). Service Documents for of those Cars indicate that this DTC should be ignored in that Module as long as the Coding matches the Vehicle Equipment.

Check/Fix Coding Pin/Bridge in Wiring
Check/Fix Control Module Coding
- See Vehicle Specific Diagnostic Procedures for Details

@@ Line 23: / Line 23: @@
 * When found in the Comfort System on the [[VW New Beetle/Cabriolet (1C/1Y/9C)]] this may be a bug in the module that will be resolved by refreshing the coding with the same value as described above with the CAN Gateway example.
-* When found in [[VW Golf (1K) Brake Electronics (MK60EC1)|Brake Electronics (MK60EC1)]] when the coding is NOT all zeros, check the 19-CAN Gateway coding.  The incorrect LHD/RHD configuration will cause this.
+* When found in [[VW Golf (1K) Brake Electronics (MK60EC1)|Brake Electronics (MK60EC1)]] while the Coding is NOT all Zeros, check the '''[19-CAN Gateway]''' > '''[Coding - 07]'''.  An incorrect LHD/RHD Configuration may cause this Fault Code.
 == 01044 - Control Module Incorrectly Coded: Implausible Signal ==