Difference between revisions of "01044"

Revision as of 18:11, 23 January 2014

When found in CAN-Gateway:
- On a Long Coded module, use the Gateway Installation List to check for unreachable or not registered control modules. Then update the Gateway [Installation List] by altering the Gateway Coding manually.
- On a Short Coded modules, refresh the original coding with the same value. For example, code it from 00006 -to- 00006 without making an actual change.
When found in VW New Beetle/Cabriolet (1C/1Y/9C): Comfort System, this may be a Bug in the Control Module Software that will be resolved by refreshing the Coding with the same Value as described above with the CAN Gateway example.
When found in Brake Electronics (MK60EC1) while the Coding is NOT all Zeros, check the [19-CAN Gateway] > [Coding - 07]. An incorrect LHD/RHD Configuration may cause this Fault Code.

Some Passat (3B/B5) around MY 2000 have a Firmware Bug which causes this DTC to be set in the CAN Gateway (19). Service Documents for of those Cars indicate that this DTC should be ignored in that Module as long as the Coding matches the Vehicle Equipment.

Check/Fix Coding Pin/Bridge in Wiring
Check Control Module part numbers
Check/Fix Control Module Coding
- See Vehicle Specific Diagnostic Procedures for Details

@@ Line 49: / Line 49: @@
 * Coding Pin/Bridge does not match
+* Incorrect Control Module Installed
 * Control Module incorrectly coded
@@ Line 54: / Line 55: @@
 * Check/Fix Coding Pin/Bridge in Wiring
+* Check Control Module part numbers
 * Check/Fix [http://www.ross-tech.com/vag-com/tour/recode_screen.html Control Module Coding]
 ** See [[Diagnostic_Procedures|Vehicle Specific Diagnostic Procedures]] for Details
 [[Category:Fault Codes]]