Difference between revisions of "01487"

From Ross-Tech Wiki
(New page: __FORCETOC__ == 01487 - System Function Test == === 01487 - System Function Test: Implausible Signal === ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) ON ==== Possibl...)
 
m
Line 15: Line 15:
 
==== Special Notes ====
 
==== Special Notes ====
  
* When found in [[Audi A8 (4E)], this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197).
+
* When found in [[Audi A8 (4E)]], this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197).
  
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Revision as of 06:01, 22 May 2009

01487 - System Function Test

01487 - System Function Test: Implausible Signal

Possible Symptoms

  • Malfunction Indicator Light (MIL) ON

Possible Causes

  • Internal Error in Control Module for Level Control (J197)
  • Control Module for Level Control (J197) faulty

Special Notes

  • When found in Audi A8 (4E), this Fault Code can have several different Reasons but by clearing Fault Codes most of those will be reset. Switch OFF the Ignition for 5 Seconds and then switch it back ON again, now clear Fault Codes and re-check for Fault Codes. If no Fault Code remains you are done. If the fault code remains, switch OFF the Ignition for 5 Seconds again and then switch it back ON. Now wait 5 Minutes before re-checking for Fault Codes! If after these 5 Minutes the Fault Code remains you may need to replace the Control Module for Level Control (J197).