Difference between revisions of "02628"

From Ross-Tech Wiki
Line 13: Line 13:
 
** Connectors not properly attached AND/OR Pins widened
 
** Connectors not properly attached AND/OR Pins widened
 
** Connectors wet/corroded
 
** Connectors wet/corroded
* Sensor for Swivel Module Position Right faulty
+
* G475 - Sensor for Swivel Module Position Right faulty
  
 
==== Possible Solutions ====
 
==== Possible Solutions ====

Revision as of 10:56, 27 September 2013

02628 - Sensor for Swivel Module Position; Right

02628 - Sensor for Swivel Module Position; Right : Defective

Possible Symptoms

  • Malfunction Indicator Light (MIL) active

Possible Causes

  • Wiring/Connectors from/to Sensor for Swivel Module Position Right faulty
    • Connectors not properly attached AND/OR Pins widened
    • Connectors wet/corroded
  • G475 - Sensor for Swivel Module Position Right faulty

Possible Solutions

  • Check/Repair Wiring/Connectors from/to Sensor for Swivel Module Position Right
  • Check/Replace Sensor for Swivel Module Position Right
    • Sensor may be part of the Headlight and the complete Headlight may need to be replaced

Special Notes

  • When found in Volkswagen Passat (3C): Headlight Leveling, check TPI 2012732.
    • If the Fault Code is static (not intermittent) and the Right Subsystem/Slave Swiveling Module has Software Level X017 or lower just replace the Swiveling Module - do NOT replace the Headlight/Housing at this point.
    • If the Fault Code is intermittent and the Right Subsystem/Slave Swiveling Module has Software Level X017 or lower replace the Swiveling Module and the Headlight/Housing.
    • If the Right Subsystem/Slave Swiveling Module has Software Level X018 replace only the Headlight/Housing.