Difference between revisions of "16600/P0216/000534"

From Ross-Tech Wiki
(Created page with "== 16600/P0216 - Commencement of Injection Valve (N108): Circuit Malfunction == ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) active * Reduced fuel economy...")
 
Line 19: Line 19:
 
==== Special Notes ====
 
==== Special Notes ====
  
* N108 for the ALH engine should be between 12 to 20 ohms.
+
* For the ALH engine
 +
** The N108 should be between 12 to 20 ohms.
 +
** With the engine at idle and up to operating temperature, go into Basic Settings group 004.  Field 3 should should read between 7.0 to 9.0 degrees, then about 10 seconds later drop to 3.0 to 5.0 degrees.
 
* If air is getting sucked into the fuel supply, this can cause the P0216. Check for cracks at the fuel pick up in the fuel tank, and at the fittings for the fuel filter.
 
* If air is getting sucked into the fuel supply, this can cause the P0216. Check for cracks at the fuel pick up in the fuel tank, and at the fittings for the fuel filter.
  

Revision as of 16:50, 29 May 2015

16600/P0216 - Commencement of Injection Valve (N108): Circuit Malfunction

Possible Symptoms

  • Malfunction Indicator Light (MIL) active
  • Reduced fuel economy and engine performance

Possible Causes

  • Electrical Path Issue with N108
  • Mechanical issue with N108
  • Mechanical issue with Injection Pump

Possible Solutions

  • Ohm test N108 and wiring harness, see factory repair manual
  • Replace failed N108 or failed Injection Pump.

Special Notes

  • For the ALH engine
    • The N108 should be between 12 to 20 ohms.
    • With the engine at idle and up to operating temperature, go into Basic Settings group 004. Field 3 should should read between 7.0 to 9.0 degrees, then about 10 seconds later drop to 3.0 to 5.0 degrees.
  • If air is getting sucked into the fuel supply, this can cause the P0216. Check for cracks at the fuel pick up in the fuel tank, and at the fittings for the fuel filter.