Difference between revisions of "18010/P1602/005634"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
|||
| Line 17: | Line 17: | ||
* If multiple Control Module have Power Supply Faults stored, it's most likely to be one common Problem like the ones shown above. Otherwise when only one or two Control Modules have such Codes stored you better start searching at the individual Power Supply of these Modules. | * If multiple Control Module have Power Supply Faults stored, it's most likely to be one common Problem like the ones shown above. Otherwise when only one or two Control Modules have such Codes stored you better start searching at the individual Power Supply of these Modules. | ||
| + | |||
| + | * Terminal 30 means unswitched battery power that is supplied even when the ignition is off. This is not referring to any physical terminal numbered 30. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 10:12, 11 February 2011
18010/P1602/005634 - Power Supply B+ Terminal 30: Voltage too Low
Possible Causes
- Cables on the Battery were removed
- Battery weak (voltage)
- Generator Disfunction
Possible Solutions
- Check Battery Cables
- Check/Replace Battery
- Check/Replace Generator
Special Notes
- If multiple Control Module have Power Supply Faults stored, it's most likely to be one common Problem like the ones shown above. Otherwise when only one or two Control Modules have such Codes stored you better start searching at the individual Power Supply of these Modules.
- Terminal 30 means unswitched battery power that is supplied even when the ignition is off. This is not referring to any physical terminal numbered 30.