Difference between revisions of "18074/P1666"

From Ross-Tech Wiki
 
 
(2 intermediate revisions by one other user not shown)
Line 14: Line 14:
  
 
* Check wiring and Check / Clean all connections
 
* Check wiring and Check / Clean all connections
* Replace all cables to/from all the Valves for Pump Jet
+
* Replace the cable-tree to/from all the Valves for Pump Jet
 
* Replace Valve for Pump Jet (replace them all !)
 
* Replace Valve for Pump Jet (replace them all !)
  
 
==== Special Notes ====
 
==== Special Notes ====
  
* For each Valve the ECU checks the Begin of Injection Period (BIP) via a voltage. That voltage is very small (less
+
* The ECU checks the Begin of Injection Period (BIP) by sending a very small amount of current (less than 0.0001 A ) through each injector. Because the current is so small, any extra resistance in the wiring due to damage or corrosion can cause this fault. Before replacing injectors, replace the wiring harness first.
than 0.0001A). Each extra resistance in the cable is fatal. So, in case of any doubt, just replace all cables.
 
  
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Latest revision as of 17:45, 3 December 2010

18074/P1666 - Valve for Pump - Jet: Cylinder 1 (N240): Electrical Malfunction

Possible Symptoms

  • Irregular rpm

Possible Causes

  • Wiring and/or connections to/from the Valve for Pump Jet
  • Valve for Pump Jet

Possible Solutions

  • Check wiring and Check / Clean all connections
  • Replace the cable-tree to/from all the Valves for Pump Jet
  • Replace Valve for Pump Jet (replace them all !)

Special Notes

  • The ECU checks the Begin of Injection Period (BIP) by sending a very small amount of current (less than 0.0001 A ) through each injector. Because the current is so small, any extra resistance in the wiring due to damage or corrosion can cause this fault. Before replacing injectors, replace the wiring harness first.