Difference between revisions of "18439/P2007/008199"

From Ross-Tech Wiki
Line 20: Line 20:
 
==== Special Notes ====
 
==== Special Notes ====
  
* When found in 2005 - 2008 Audi A4 and A6 with 3.2L FSI engines, please see TSB 2019485/1.
+
* When found in 2005 - 2008 Audi A4 and A6 with BKH 3.2L FSI engines, please see TSB 2019485/1 or 24-08-76.
 
** If this fault is found after cylinder head and/or intake manifold removal repairs verify the vacuum operated Intake Manifold Runners do not have obstructed movement.
 
** If this fault is found after cylinder head and/or intake manifold removal repairs verify the vacuum operated Intake Manifold Runners do not have obstructed movement.
 +
** If the ports on the intake manifold (which supply intake flap/ tuning valve solenoids) have insufficient vacuum, make sure the solenoid  under the air filter housing isn't broken/leaking.  This can cause a leak in the circuit connected to the mechanical vacuum pump on the right cylinder head  resulting in [[18438/P2006/008198|P2006]],[[18439/P2007/008199 |P2007]] and [[18502/P2070/008304|P2070]].
  
 
__FORCETOC__
 
__FORCETOC__
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Revision as of 10:07, 8 July 2019

18439/P2007/008199 - Intake Manifold Runner Control Stuck Closed, Bank 2

Possible Symptoms

  • MIL On
  • Reduction of power at higher RPMs

Possible Causes

  • Vacuum leak
  • Faulty Intake Manifold Runner Position Sensor2 (G512)
  • Intake Manifold Runner binding or sticking

Possible Solutions

  • Replace failed vacuum line
  • Check Intake Manifold Runner Position Sensor 2 (G512) and wiring, see repair manual.

Special Notes

  • When found in 2005 - 2008 Audi A4 and A6 with BKH 3.2L FSI engines, please see TSB 2019485/1 or 24-08-76.
    • If this fault is found after cylinder head and/or intake manifold removal repairs verify the vacuum operated Intake Manifold Runners do not have obstructed movement.
    • If the ports on the intake manifold (which supply intake flap/ tuning valve solenoids) have insufficient vacuum, make sure the solenoid under the air filter housing isn't broken/leaking. This can cause a leak in the circuit connected to the mechanical vacuum pump on the right cylinder head resulting in P2006,P2007 and P2070.