2.0L CR TDI

From Ross-Tech Wiki

Coding

Coding-II

Cruise Control Activation in addition to Exhaust Gas Differential Pressure Sensor (G450) Adaptation is performed using the Coding-II function in vehicles with a CAN Protocol EDC. UDS Protocol control modules do not support this method of G450 Adaptation and Basic Settings are used instead.

Instructions should be populated in a pop-up balloon when connected to the controller in question.

  • Key ON, Engine OFF
  • [Coding-2] or [Login-II] button
  • Enter the code shown in the VCDS pop-up balloon
  • [Do It!]
  • Switch Ignition OFF for 30 seconds

After the key is cycled back on the adaptation should be completed. If it is not completed, proceed with the next steps:

These steps must be repeated 5 times.

  • Ignition ON
  • Wait 5 seconds
  • Ignition OFF
  • Wait 40 seconds
  • Repeat 4 more times

Note: If a code is NOT shown in the VCDS pop-up balloon registered customers can Join our Forum -or- send the complete Auto-Scan via email with the recent repair history including the part number of the original/removed sensor and the new replacement sensor.

Adaptation

Basic Setting

Special Functions

Injector Quantity Adjustment (IMA) and Injector Voltage Adjustment (ISA)

These values represent the behavior of an injection valve (Piezo Injector). Caused by manufacturing tolerances the injectors have a unique behavior and get divided into separate classes. In combination with the automatically determined learning values of the engine control module the pre- and post-injections are being calculated individually for each valve. The behavior of an injection valve is also mileage dependent, so a valve with e.g. 10000 km has a different behavior then one with 70000 km. The control module determines these automatically while driving so the learning values change against the mileage. When altering one of the following values the learning values are being reset because the ECU thinks you are adjusting a new valve.

The IMA-ISA values need to be adapted when:

  • One or more injection valves have been replaced. Make sure not to adjust the valves which have not been changed!
  • The engine control module has been replaced.
  • Do NOT adapt these values when you did not replace one of the above parts, also not for training or demonstration purposes.

The adjustment code can be found on the injector itself, it is a 7-digit value and does only use the following chars: 1,2,3,4,5,6,7,8,A,B,C,D,E,F,G,H,K,L,M,N,O,P,R,S,T,U,V,W,X,Y,Z. A value of AAAAAAA is also not valid.

Prerequisites:

  • Ignition ON
  • Engine OFF

[Select]
[01 - Engine]

[Adaptation - 10]
Channel 071: IMA-ISA Value for Cylinder 1
Channel 072: IMA-ISA Value for Cylinder 2
Channel 073: IMA-ISA Value for Cylinder 3
Channel 074: IMA-ISA Value for Cylinder 4
[Test]
[Save]
[Done, Go Back]

  • Switch Ignition OFF, wait 10 seconds and switch Ignition ON again. The values should be saved now, please verify them by double checking the adaptation values.