Audi A4 (8E) Airbag 9.41

From Ross-Tech Wiki
Revision as of 11:11, 20 April 2006 by RtWiKiSyS0p (talk | contribs)


Coding

  • 0?3xxxx: Battery Seperating
    • 0 = without Battery Seperating
    • 4 = with Battery Seperating (4.2l V8 only / PR-TK7)
  • 0x3?xxx: Options'
    • 0 = with/without Belt Warning (PR-4UE+9P0/9P1)
    • 1 = Passenger Airbag with Key Switch / Belt Warning (PR-4UE+9P0/9P1)
    • 2 = Passenger Airbag with Seat Occupation Detection / Belt Warning (PR-4UB+9P5)
    • 3 = with Belt Warning (PR-4UE+9P3) OR Passenger Airbag with Seat Occupation Detection / Belt Warning (PR-4UB+9P3)
    • 4 = Passenger Airbag with Key Switch / Belt Warning (PR-4UF+9P3)
  • 0x3x?xx: Side Airbags
    • 6 = Front Side Airbags with Head Airbags (PR-4X3)
    • 7 = Front & Rear Side Airbags with Head Airbags (PR-4X4)
  • 0x3xx?x: Belt Inquiry
    • 0 = North America (USA/Canada) OR Rest of World (RoW): without Belt Inquiry (PR-9P0)
    • 1 = Rest of World (RoW): Belt Inquiry Driver's Side (PR-9P1)
    • 2 = Rest of World (RoW): Belt Inquiry Driver's & Passenger Side (PR-9P3)
  • 0x3xxx?: Belt Tensioner
    • 2 = Rest of World (RoW): Front Belt Tensioner
    • 2 = Rest of World (RoW) & Belt Inquiry (PR-9P1): Front & Rear Belt Tensioner
    • 7 = Rest of World (RoW) & Belt Inquiry (PR-9P0/9P3): Front & Rear Belt Tensioner
    • 7 = North America (USA/Canada)


Adaptation

Used to deactivate individual airbag components (see repair manual for details).

Basic Setting

Seat Occupied Recognition Control Module (J706)

If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 30475, to enable the basic setting.
If you are having problems performing this security access, contact us.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]

Special Procedures

Seat Occupied Recognition Control Module (J706): Reset

If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.

Prerequisites:

  • Seat in normal position.
  • Seat must NOT be occupied during the whole procedure.
  • Seatbelt must NOT be plugged in.
  • No faults in the system.
  • Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 30475, to enable the basic setting.
If you are having problems performing this security access, contact us.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]