Difference between revisions of "Audi A6 (4F) Airbag"

From Ross-Tech Wiki
Line 3: Line 3:
 
== Coding ==
 
== Coding ==
  
VCDS will automatically tell you a suggested coding (HEX interface required), otherwise [http://www.ross-tech.com/contact.html contact us] for assistance.<br><br>
+
VCDS will automatically tell you a suggested [[Airbag Coding]] (HEX interface required), otherwise [http://www.ross-tech.com/contact.html contact us] for assistance.<br><br>
  
 
== Adaptation ==
 
== Adaptation ==
  
Used to deactivate individual airbag components (see repair manual for details).<br><br>
+
Used to deactivate individual airbag components (see repair manual for details).
 +
 
 +
=== Channel 050: ESP-Data (Powertrain) ===
 +
* 1 = Front-Wheel-Drive (FWD)
 +
* 2 = All-Wheel-Drive (AWD)
 +
 
 +
=== Channel 051: ESP-Data (Brake) ===
 +
* 08 = FN3 16" (PR-1LF/1LT)
 +
* 12 = FNRG60 16" (PR-1LG)
 +
* 16 = FNRG60 17" (PR-1ZL)
 +
 
  
 
== Basic Setting ==
 
== Basic Setting ==

Revision as of 11:51, 1 May 2013


Coding

VCDS will automatically tell you a suggested Airbag Coding (HEX interface required), otherwise contact us for assistance.

Adaptation

Used to deactivate individual airbag components (see repair manual for details).

Channel 050: ESP-Data (Powertrain)

  • 1 = Front-Wheel-Drive (FWD)
  • 2 = All-Wheel-Drive (AWD)

Channel 051: ESP-Data (Brake)

  • 08 = FN3 16" (PR-1LF/1LT)
  • 12 = FNRG60 16" (PR-1LG)
  • 16 = FNRG60 17" (PR-1ZL)


Basic Setting

Seat Occupied Recognition Control Module (J706)

If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 20324, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]

Special Procedures

Seat Occupied Recognition Control Module (J706): Reset

If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.

Prerequisites:

  • Seat in normal position.
  • Seat must NOT be occupied during the whole procedure.
  • Seatbelt must NOT be plugged in.
  • No faults in the system.
  • Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 20324, to enable the basic setting.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]