Difference between revisions of "Audi A6 (4F) Brake Electronics"

From Ross-Tech Wiki
(One intermediate revision by one other user not shown)
Line 1: Line 1:
 
__FORCETOC__
 
__FORCETOC__
 
== Coding ==
 
== Coding ==
 +
 +
Most repair manual sources do not cover this Bosch 8.0 ABS system.  When the module is replaced with new it is advised to use the original coding value from the old unit. If this is not possible, registered users can [http://www.ross-tech.com/contact.html  contact us directly] with a complete  [http://www.ross-tech.com/vcds/tour/autoscan.html  Auto Scan] and VIN number.
 +
 +
Minor modifications for retrofitting purposes include:
 
* +0016384 =  Trailer Hitch not installed or w/o Control Module for Trailer/Towing Sensor (J345)
 
* +0016384 =  Trailer Hitch not installed or w/o Control Module for Trailer/Towing Sensor (J345)
  
Line 34: Line 38:
  
 
* After doing the G85 Calibration, you may get a 01486 - System Function Test Active, this is normal.  Please see [[01486]].
 
* After doing the G85 Calibration, you may get a 01486 - System Function Test Active, this is normal.  Please see [[01486]].
 +
 +
----
 +
 +
== Replacement ==
 +
 +
*  First, Code the module with the original coding value from the old unit. No Login or Security Access is needed.
 +
*  Next, perform the G85 Calibration.
 +
*  Make sure that no faults are present and that the ABS and ESP lamps are off when you exit out of the controller.

Revision as of 11:06, 19 February 2014

Coding

Most repair manual sources do not cover this Bosch 8.0 ABS system. When the module is replaced with new it is advised to use the original coding value from the old unit. If this is not possible, registered users can contact us directly with a complete Auto Scan and VIN number.

Minor modifications for retrofitting purposes include:

  • +0016384 = Trailer Hitch not installed or w/o Control Module for Trailer/Towing Sensor (J345)


Basic Setting

Steering Angle Sensor (G85) Calibration

[Select]
[03 - ABS Brakes]

Turn steering wheel at least 30 ° left and back straight ahead.

[Security Access - 16]
Enter 40168
[Do It!]

[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 3 should say "OK".
[Done, Go Back]

[Fault Codes - 02]
All fault codes should have disappeared.
[Done, Go Back]

[Close Controller, Go Back - 06]

Special Note

  • After doing the G85 Calibration, you may get a 01486 - System Function Test Active, this is normal. Please see 01486.

Replacement

  • First, Code the module with the original coding value from the old unit. No Login or Security Access is needed.
  • Next, perform the G85 Calibration.
  • Make sure that no faults are present and that the ABS and ESP lamps are off when you exit out of the controller.