Difference between revisions of "Audi A6 (4F) Headlight Aim Control (Adaptive Light)"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) |
RtWiKiSyS0p (talk | contribs) m |
||
Line 13: | Line 13: | ||
* 0000025 = Audi TT (8J) with Magnetic Ride | * 0000025 = Audi TT (8J) with Magnetic Ride | ||
− | '''''Note''': Perform Security Access before Coding!'' | + | '''''Note''': Perform Security Access before Coding and Basic Setting (Headlight Adjustment) after Coding!'' |
+ | |||
+ | |||
+ | == Security Access == | ||
+ | |||
+ | * 02000 = General Coding "Enabling" | ||
+ | * 02000 > 03000 > 04000 > 05000 = General Adaptation "Enabling" ''(Enter one after another)'' | ||
+ | |||
== Adaptation == | == Adaptation == | ||
Line 35: | Line 42: | ||
Don't forget to check/clear fault codes afterwards.<br> | Don't forget to check/clear fault codes afterwards.<br> | ||
'''[Close Controller, Go Back - 06]'''<br> | '''[Close Controller, Go Back - 06]'''<br> | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− |
Revision as of 06:58, 31 July 2007
Coding
- 0000016 = Audi A6 (4F) with Steel Suspension
- 0000017 = Audi A6 (4F) with Air Suspension
- 0000018 = Audi A8 (4E)
- 0000019 = Audi A4 (8E)
- 0000020 = Audi A3 (8P)
- 0000021 = Audi Q7 (4L) with Steel Suspension
- 0000022 = Audi Q7 (4L) with Air Suspension
- 0000023 = Audi TT (8J) with Steel Suspension and Front Wheel Drive (FWD)
- 0000024 = Audi TT (8J) with Steel Suspension and All Wheel Drive (AWD)
- 0000025 = Audi TT (8J) with Magnetic Ride
Note: Perform Security Access before Coding and Basic Setting (Headlight Adjustment) after Coding!
Security Access
- 02000 = General Coding "Enabling"
- 02000 > 03000 > 04000 > 05000 = General Adaptation "Enabling" (Enter one after another)
Adaptation
Basic Setting
Headlight Adjustment
[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
- The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
- Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]