Difference between revisions of "Audi A6 (4F) Headlight Aim Control (Adaptive Light)"

From Ross-Tech Wiki
m
Line 23: Line 23:
  
 
== Adaptation ==
 
== Adaptation ==
 +
=== Channel 010: Tourist Solution ===
 +
When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.
 +
* 0 = Disabled
 +
* 1 = Enabled
 +
 +
=== Channel 020: Showroom Effect ===
 +
After activating the showroom effect the dynamic cornering light at vehicle standstill can be demonstrated to the customer. The showroom effect remains active until the showroom effect is deactivated via the function program.
 +
* 0 = Disabled
 +
* 1 = Enabled
  
  

Revision as of 14:15, 21 March 2008

Coding

  • 0000016 = Audi A6 (4F) with Steel Suspension
  • 0000017 = Audi A6 (4F) with Air Suspension
  • 0000018 = Audi A8 (4E)
  • 0000019 = Audi A4 (8E)
  • 0000020 = Audi A3 (8P)
  • 0000021 = Audi Q7 (4L) with Steel Suspension
  • 0000022 = Audi Q7 (4L) with Air Suspension
  • 0000023 = Audi TT (8J) with Steel Suspension and Front Wheel Drive (FWD)
  • 0000024 = Audi TT (8J) with Steel Suspension and All Wheel Drive (AWD)
  • 0000025 = Audi TT (8J) with Magnetic Ride

Note: Perform Security Access before Coding and Basic Setting (Headlight Adjustment) after Coding!


Security Access

  • 02000 = General Coding "Enabling"
  • 02000 > 03000 > 04000 > 05000 = General Adaptation "Enabling" (Enter one after another)


Adaptation

Channel 010: Tourist Solution

When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.

  • 0 = Disabled
  • 1 = Enabled

Channel 020: Showroom Effect

After activating the showroom effect the dynamic cornering light at vehicle standstill can be demonstrated to the customer. The showroom effect remains active until the showroom effect is deactivated via the function program.

  • 0 = Disabled
  • 1 = Enabled


Basic Setting

Headlight Adjustment

[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]

  • The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
  • Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.

[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]