Audi A8 (4E) Battery Replacement

From Ross-Tech Wiki
Revision as of 15:30, 8 April 2011 by Dana (talk | contribs)

This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.

The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself. Make sure to refer to the factory repair manual in order to fulfill all additional prerequisites.

[Select]
[61 - Battery Regulation]
[Coding - 07]
[Battery Coding Assistant]

  • Enter the new Battery Part Number (10 or 11 digits).
  • Enter the new Battery Serial Number (10 digits).
  • Select the new Battery Vendor.

[OK]
[Do it!]
[Close Controller, Go Back - 06]

Your new Battery should now be coded and the Battery Control Module should be aware of the new Battery.


Note: The 10 digit serial number may be preceded by the battery vendor code, for instance VAO of Varta. If the code is VAO25402160104 then drop the VAO and just enter 25402160104: