Audi Q7 (4L) Airbag

From Ross-Tech Wiki
Revision as of 12:57, 4 May 2009 by RtWiKiSyS0p (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


Coding

VAG-COM will automatically tell you a suggested coding (HEX interface required), otherwise contact us for assistance.

Adaptation

Mostly used to deactivate individual airbag components (see repair manual for details).

Channel 050: ESP-Data (Powertrain)

  • 2 = All-Wheel-Drive (AWD)

Channel 051: ESP-Data (Brake)

  • 04 = Front Axle 350x34 (PR-1LF) & Rear Axle 330x28 (PR-1KF)
  • 04 = Front Axle 350x34 (PR-1LF) & Rear Axle 358x28 (PR-2EA)
  • 06 = Front Axle 350x34 (PR-1LF) & Rear Axle 358x28 (PR-1KD)
  • 10 = Front Axle 374x36 (PR-1LT) & Rear Axle 358x28 (PR-1KD)


Basic Setting

Seat Occupied Recognition Control Module (J706)

If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 20324, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]

Special Procedures

Seat Occupied Recognition Control Module (J706): Reset

If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.

Prerequisites:

  • Seat in normal position.
  • Seat must NOT be occupied during the whole procedure.
  • Seatbelt must NOT be plugged in.
  • No faults in the system.
  • Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 20324, to enable the basic setting.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]