Difference between revisions of "B2010"

From Ross-Tech Wiki
Line 19: Line 19:
 
*** Those TPIs discuss Audi SVM code BAA001 for the flash update in addition to a mechanical adjustment and Basic Setting procedure. The RoW document includes the S8 model.
 
*** Those TPIs discuss Audi SVM code BAA001 for the flash update in addition to a mechanical adjustment and Basic Setting procedure. The RoW document includes the S8 model.
 
* When found in an UDS EPB system, perform Basic Settings Start of operations.
 
* When found in an UDS EPB system, perform Basic Settings Start of operations.
 +
* When found in RoW market UDS protocol 17-Instrument clusters, check the service related Adaptation channels.  This thread should add clarity: https://forums.ross-tech.com/showthread.php?1874-Audi-Q3-fault-code-1048578-No-Basic-Setting
  
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Revision as of 16:18, 2 February 2020

B2010 - No Basic Setting

Possible Causes

  • Basic Setting lost

Possible Solutions

Special Notes

  • When found in the VW Touareg (7P) Trunk Electronics 6D control module perform the Rear Lid relearn.
  • When found in the BA-Motor Mounts (J931) control module (typically in conjunction with B2005) on 4G Chassis S6/S7/RS7 with 4.0T engine see:
    • NAR (North American) Market TPI 2036392
    • RoW (Rest of World) Market TPI 2036309
      • Those TPIs discuss Audi SVM code BAA001 for the flash update in addition to a mechanical adjustment and Basic Setting procedure. The RoW document includes the S8 model.
  • When found in an UDS EPB system, perform Basic Settings Start of operations.
  • When found in RoW market UDS protocol 17-Instrument clusters, check the service related Adaptation channels. This thread should add clarity: https://forums.ross-tech.com/showthread.php?1874-Audi-Q3-fault-code-1048578-No-Basic-Setting