Difference between revisions of "Diesel Particle Filter Emergency Regeneration"
RtWiKiSyS0p (talk | contribs) |
RtWiKiSyS0p (talk | contribs) m |
||
Line 28: | Line 28: | ||
Select all 3 Groups at once 070 and 075<br> | Select all 3 Groups at once 070 and 075<br> | ||
'''[Go!]'''<br> | '''[Go!]'''<br> | ||
− | MVB 070.1: Regeneration Status ''( | + | MVB 070.1: Regeneration Status ''(xxxxxxx1 = Normal Regeneration active, xxxxxx1x = Forced Regeneration active)''<br> |
MVB 070.3: Regeneration Counter/Timer<br> | MVB 070.3: Regeneration Counter/Timer<br> | ||
− | |||
MVB 075.1: Exhaust Gas Temperature before Turbo Charger<br> | MVB 075.1: Exhaust Gas Temperature before Turbo Charger<br> | ||
MVB 075.2: Exhaust Gas Temperature before Particle Filter<br> | MVB 075.2: Exhaust Gas Temperature before Particle Filter<br> | ||
Line 42: | Line 41: | ||
See [[3.0l V6 TDI (BKS/BMK/BUN)#Particle Filter Emergency Regeneration|Engine specific page]]. | See [[3.0l V6 TDI (BKS/BMK/BUN)#Particle Filter Emergency Regeneration|Engine specific page]]. | ||
− | |||
− | |||
− |
Revision as of 14:52, 11 July 2007
1.9l/2.0l TDI
Prerequisites (General):
- Ignition ON
- Engine ON (Idle)
- Coolant Temperature above 50 °C (see MVB 002.4)
- Particle Filter Load below Specification (see MVB 075.3, VAG-COM should give the specified value)
- If the Particle Filter Load is above Specification the Particle Filter needs to be replaced since the car may burn down when regenerating.
- Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control)
Conditions (Driving Cycle):
- Vehicle Speed between 30-60 km/h (18-37 MPH)
- Engine Speed between 1500-2500 RPM (4th or 5th Gear, Automatic Transmission in Tiptronic)
- Duration approx. 15-20 Minutes
- Exhaust Gas Temperature before Turbo Charger above 700 °C
Drive the car based on the above conditions until the Particle Filter Load is as low as possible (close to 0 %). In case the regeneration fails there can either be problems with the Driving Cycle Conditions or with the Engine Hardware.
[Select]
[01 - Engine]
[Coding-II - 11]
- Start Regeneration by Entering 21295.
[Do It!]
[Meas. Blocks - 08]
Select all 3 Groups at once 070 and 075
[Go!]
MVB 070.1: Regeneration Status (xxxxxxx1 = Normal Regeneration active, xxxxxx1x = Forced Regeneration active)
MVB 070.3: Regeneration Counter/Timer
MVB 075.1: Exhaust Gas Temperature before Turbo Charger
MVB 075.2: Exhaust Gas Temperature before Particle Filter
MVB 075.3: Particle Filter Load
MVB 075.4: Exhaust Gas Temperature after Particle Filter
[Done, Go Back]
[Close Controller, Go Back - 06]
3.0l V6 TDI (BKS/BMK/BUN)
See Engine specific page.