Difference between revisions of "Exhaust Gas Recirculation (EGR) Valve Adaptation"

From Ross-Tech Wiki
 
 
(One intermediate revision by one other user not shown)
Line 1: Line 1:
__FORCETOC__
+
__NOTOC__
 
== Most VW/Audi/Seat/Skoda gasoline engines with Exhaust Gas Recirculation (EGR) ==
 
== Most VW/Audi/Seat/Skoda gasoline engines with Exhaust Gas Recirculation (EGR) ==
  
Line 5: Line 5:
 
* Ignition ON
 
* Ignition ON
 
* Engine OFF
 
* Engine OFF
* Battery voltage at least 11.5 V
+
* Battery voltage: 12.5 V or higher
* For ECU's using ME 7.5, the coolant temp needs to be between 10 and 50 °C
+
 
  
 
'''[Select]'''<br>
 
'''[Select]'''<br>
Line 21: Line 21:
 
'''[Switch to Measuring Blocks]'''<br>
 
'''[Switch to Measuring Blocks]'''<br>
 
'''[Close Controller, Go Back - 06]'''<br><br>
 
'''[Close Controller, Go Back - 06]'''<br><br>
 +
 +
'''<u>Special Notes:</u>'''<br>
 +
* For ECU's using ME 7.5, the coolant temp needs to be between 10 and 50 °C.
 +
* In case the adaptation fails switch OFF the Ignition for 30 Seconds, then switch it ON and try again.

Latest revision as of 11:41, 28 September 2022

Most VW/Audi/Seat/Skoda gasoline engines with Exhaust Gas Recirculation (EGR)

Prerequisites (General):

  • Ignition ON
  • Engine OFF
  • Battery voltage: 12.5 V or higher


[Select]
[01 - Engine]
[Meas. Blocks - 08]
Select Group 074.
[Go!]
MVB 074.1: Min Position in Volts
MVB 074.2: Max Position in Volts
MVB 074.3: Potentiometer voltage
MVB 074.4: Adaption status: (Run/OK/etc)
[Switch to Basic Settings]
MVB 074.4: Adaption status: (Run) then it should change to (ADP OK)
[Switch to Measuring Blocks]
[Close Controller, Go Back - 06]

Special Notes:

  • For ECU's using ME 7.5, the coolant temp needs to be between 10 and 50 °C.
  • In case the adaptation fails switch OFF the Ignition for 30 Seconds, then switch it ON and try again.