Difference between revisions of "Immobilizer I ECU Swapping"

From Ross-Tech Wiki
Line 12: Line 12:
  
  
== ECU Swapping (Audi) ==
+
== ECU Swapping ==
 
 
'''<u>Prerequisites:</u>'''<br>
 
* Battery voltage at least 12.0 V.<br>
 
* Valid/matched key(s).<br>
 
 
 
 
 
'''[Select]'''<br>
 
'''[25 - Immobilizer]'''<br>
 
''or in vehicles with Immobilizer included in Instrument Cluster''<br>
 
'''[17 - Instruments]'''<br>
 
'''[Adaptation - 10]'''<br>
 
Enter 000 in "Channel Number".<br>
 
'''[Adaptation - 10]'''<br>
 
Channel 000<br>
 
'''[Read]'''<br>
 
'''[Save]'''<br>
 
'''[Done, Go Back]'''<br>
 
'''[Close Controller, Go Back - 06]'''<br>
 
 
 
* Switch OFF the ignition and after 5 seconds switch it ON again.
 
* Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine.
 
 
 
 
 
 
 
== ECU Swapping (Seat/Skoda/Volkswagen) ==
 
  
 
'''<u>Prerequisites:</u>'''<br>
 
'''<u>Prerequisites:</u>'''<br>

Revision as of 20:30, 2 May 2006

This procedure details how to swap engine control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.

Determining IMMO-ID

[Select]
[25 - Immobilizer]
or in vehicles with Immobilizer included in Instrument Cluster
[17 - Instruments]
Look at the first "Extra" field. You should see something like: Immo-ID VWZ7Z0W0648696.
[Close Controller, Go Back - 06]


ECU Swapping

Prerequisites:

  • Battery voltage at least 12.0 V.


[Select]
[25 - Immobilizer]
or in vehicles with Immobilizer included in Instrument Cluster
[17 - Instruments]
[Login - 11]
There are 2 possibilities how to enter a PIN, choose the one that applies for you.

  • 4-digit PIN
    • Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.
  • 7-digit PIN
    • [Use 7-digit PIN/SKC]
    • Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
    • [OK]
    • VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Do it!]

[Adaptation - 10]
Enter 000 in "Channel Number".
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

  • Switch OFF the ignition and after 5 seconds switch it ON again.
  • Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine.