Difference between revisions of "Immobilizer I Immobilizer Swapping (Separate)"

From Ross-Tech Wiki
m
 
(2 intermediate revisions by 2 users not shown)
Line 20: Line 20:
 
'''[25 - Immobilizer]'''<br>
 
'''[25 - Immobilizer]'''<br>
 
'''[Login - 11]'''<br>
 
'''[Login - 11]'''<br>
''There are 2 possibilities how to enter a PIN, choose the one that applies for you.''
 
 
* '''4-digit PIN'''
 
* '''4-digit PIN'''
 
** Enter zero followed by the 4-digit PIN. ''For example, if your PIN is 1234, enter 01234.''
 
** Enter zero followed by the 4-digit PIN. ''For example, if your PIN is 1234, enter 01234.''
* '''7-digit PIN'''
 
** '''[Use 7-digit PIN/SKC]'''
 
** Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
 
** '''[OK]'''
 
** VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".
 
 
'''[Do it!]'''<br>
 
'''[Do it!]'''<br>
  
'''[Adaptation - 10]'''<br>
+
 
Enter 000 in "Channel Number".<br>
 
 
'''[Adaptation - 10]'''<br>
 
'''[Adaptation - 10]'''<br>
 
Channel 000<br>
 
Channel 000<br>
Line 40: Line 33:
  
 
* Switch OFF the ignition and after 5 seconds switch it ON again.
 
* Switch OFF the ignition and after 5 seconds switch it ON again.
* Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine.
+
* Make sure NOT to start the car within the next 2 minutes.
 +
 
 +
After that, [[Immobilizer I Key Matching (Separate)|Match the vehicle Keys]].

Latest revision as of 10:31, 23 July 2014

This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.

Determining IMMO-ID

[Select]
[25 - Immobilizer]
Look at the first "Extra" field. You should see something like: Immo-ID VWZ7Z0W0648696.
[Close Controller, Go Back - 06]


Immobilizer Control Module Swapping

Prerequisites:

  • Battery voltage at least 12.0 V.
  • Keys matched to Immobilizer Control Module


[Select]
[25 - Immobilizer]
[Login - 11]

  • 4-digit PIN
    • Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.

[Do it!]


[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

  • Switch OFF the ignition and after 5 seconds switch it ON again.
  • Make sure NOT to start the car within the next 2 minutes.

After that, Match the vehicle Keys.