Difference between revisions of "Immobilizer I Immobilizer Swapping (Separate)"

From Ross-Tech Wiki
(New page: __FORCETOC__ This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I. == Determining IMMO-ID == '''[Select]'''<br> '''[25 - Immob...)
 
m
Line 14: Line 14:
 
'''<u>Prerequisites:</u>'''<br>
 
'''<u>Prerequisites:</u>'''<br>
 
* Battery voltage at least 12.0 V.<br>
 
* Battery voltage at least 12.0 V.<br>
* Keys matches to Immobilizer Control Module
+
* Keys matched to Immobilizer Control Module
  
  

Revision as of 06:14, 9 June 2011

This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.

Determining IMMO-ID

[Select]
[25 - Immobilizer]
Look at the first "Extra" field. You should see something like: Immo-ID VWZ7Z0W0648696.
[Close Controller, Go Back - 06]


Immobilizer Control Module Swapping

Prerequisites:

  • Battery voltage at least 12.0 V.
  • Keys matched to Immobilizer Control Module


[Select]
[25 - Immobilizer]
[Login - 11]
There are 2 possibilities how to enter a PIN, choose the one that applies for you.

  • 4-digit PIN
    • Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.
  • 7-digit PIN
    • [Use 7-digit PIN/SKC]
    • Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
    • [OK]
    • VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".

[Do it!]

[Adaptation - 10]
Enter 000 in "Channel Number".
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]

  • Switch OFF the ignition and after 5 seconds switch it ON again.
  • Make sure NOT to start the car within the next 2 minutes. After that, try starting the engine.