Difference between revisions of "Level Control Bleeding/Charging"
| (One intermediate revision by one other user not shown) | |||
| Line 38: | Line 38: | ||
'''[Basic Settings-04]'''<br> | '''[Basic Settings-04]'''<br> | ||
| − | *Group | + | *Group 023 = to Charge Pressure Accumulator |
| − | *Group | + | *Group 024 = to Charge Front Axle |
| − | *Group | + | *Group 025 = to Charge Rear Axle |
'''[Go!]'''<br> | '''[Go!]'''<br> | ||
| Line 51: | Line 51: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | *These instructions should work with most non- | + | *These instructions should work with most non-UDS Level Control systems found in: |
**A6 | **A6 | ||
**A8 | **A8 | ||
Latest revision as of 12:18, 27 November 2023
Ross-Tech is not responsible for any damage or problems that may result from following these instructions. They are to be used at your own risk. As always, you should refer to a Factory Repair Manual for your vehicle!
Bleeding
Prerequisites:
- Doors, hood and rear lid closed
- Engine at idle
Note: The bleeding procedure will lower the vehicle, proceed with caution and refer to the factory repair manual for proper repair information, warnings and cautions!
[Select]
[34-Level Control]
[Security Access-16]
Enter 08367
- If the Security Access code does not work, try 08367 in [Login - 11] or [Coding II - 11]
[Basic Settings-04]
- Group 020 = to Bleed Pressure Accumulator
- Group 021 = to Bleed Front Axle
- Group 022 = to Bleed Rear Axle
[Go!]
[ON/OFF/Next]
Field-4 will display the current pressure Note: System will time out after 60 seconds, the procedure maybe repeated as necessary to achieve the desired system pressure.
Charging
Prerequisites:
- Doors, hood and rear lid closed
- Engine at idle
[Select]
[34-Level Control]
[Security Access-16]
Enter 08367
- If the Security Access code does not work, try 08367 in [Login - 11] or [Coding II - 11]
[Basic Settings-04]
- Group 023 = to Charge Pressure Accumulator
- Group 024 = to Charge Front Axle
- Group 025 = to Charge Rear Axle
[Go!]
[ON/OFF/Next]
Field-[4] will display the current pressure Note: System will time out after 60 seconds, the procedure maybe repeated as necessary to achieve the desired system pressure.
Special Notes
- These instructions should work with most non-UDS Level Control systems found in:
- A6
- A8
- Q7
- Phaeton
- Touareg
- Bentley Continental.
- http://forums.ross-tech.com/showthread.php?1996-Level-Control-Bleeding-Charging