Level Control Bleeding/Charging

From Ross-Tech Wiki
Revision as of 17:09, 4 August 2017 by Jef (talk | contribs) (Created page with " == Bleeding == '''<u>Prerequisites:</u>'''<br> *Doors, hood and rear lid closed *Engine at idle Note: The bleeding procedure will lower the vehicle, proceed with caution a...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


Bleeding

Prerequisites:

  • Doors, hood and rear lid closed
  • Engine at idle

Note: The bleeding procedure will lower the vehicle, proceed with caution and refer to the factory repair manual for proper repair information, warnings and cautions!

[Select]
[34-Level Control]
[Security Access-16]
Enter 08367

  • If the Security Access code does not work, try 08367 in [Login - 11] or [Coding II - 11]

[Basic Settings-04]

  • Group 020 = to Bleed Pressure Accumulator
  • Group 021 = to Bleed Front Axle
  • Group 022 = to Bleed Rear Axle

[Go!]
[ON/OFF/Next]

Field-4 will display the current pressure Note: System will time out after 60 seconds, the procedure maybe repeated as necessary to achieve the desired system pressure.

Charging

Prerequisites:

  • Doors, hood and rear lid closed
  • Engine at idle

[Select]
[34-Level Control]
[Security Access-16]
Enter 08367

  • If the Security Access code does not work, try 08367 in [Login - 11] or [Coding II - 11]

[Basic Settings-04]

  • Group [023] = to Charge Pressure Accumulator
  • Group [024] = to Charge Front Axle
  • Group [025] = to Charge Rear Axle

[Go!]
[ON/OFF/Next]

Field-[4] will display the current pressure Note: System will time out after 60 seconds, the procedure maybe repeated as necessary to achieve the desired system pressure.


Special Notes