Difference between revisions of "P310B/012555"

From Ross-Tech Wiki
 
(13 intermediate revisions by 3 users not shown)
Line 11: Line 11:
 
* Faulty Fuel Pressure Sensor (G410)
 
* Faulty Fuel Pressure Sensor (G410)
 
* Wiring Harness for Fuel Pressure Sensor (G410)
 
* Wiring Harness for Fuel Pressure Sensor (G410)
 +
* Low Fuel Pressure
 +
** Weak Lift Pump
 +
** Restriction in Fuel Filter or Fuel Lines
 +
* Mechanical issue with High Pressure Fuel Pump
 +
* Replacement fuel filter not correct Bar rating (ex. 4.0 Bar vs 6.0 Bar)
  
 
==== Possible Solutions ====
 
==== Possible Solutions ====
Line 16: Line 21:
 
* Replace Fuel Pressure Sensor (G410)
 
* Replace Fuel Pressure Sensor (G410)
 
* Repair Damaged Wiring
 
* Repair Damaged Wiring
 +
* Remove and inspect High Pressure Fuel Pump
 +
* Check Pressure Limiting Valve installed on the high pressure fuel rail when applicable
  
 
==== Special Notes ====
 
==== Special Notes ====
  
# When found in '''VW''' "FSI" Direct Injection engines, may also have DTC [[P129F/004767]].  Can be caused by a faulty G410 sensor.  See TSB 01-07-69 or 01-11-11  (TPI 2016182) for more information on testing and updated part numbers.
+
* When found in '''VW''' "FSI" Direct Injection engines, may also have DTC [[P129F/004767]].  Can be caused by a faulty G410 sensor.  See TSB 01-07-69 or 01-11-11  (TPI 2016182) for more information on testing and updated part numbers.
# When found in '''VW''' "FSI" Direct Injection engines, may also have DTCs P129F, P008B, P129E, P008A, P2540 and/or P0087. See TSB 01-11-28 (TPI  2027458) for information which is similar to the first noted TSB.
+
* When found in '''VW''' "FSI" Direct Injection engines, may also have DTCs P129F, P008B, P129E, P008A, P2540 and/or P0087. See TSB 01-11-28 (TPI  2027458) for information which is similar to the first noted TSB.
#* The G410 Fuel Pressure Sensor has a VW Warranty Extension in the US market due to premature failure.  Regardless of the vehicle brand, contact the local dealer with the full VIN to see if warranty extensions, recalls or RVU (required vehicle updates) apply.
+
** https://static.nhtsa.gov/odi/tsbs/2012/SB-10044939-4844.pdf  NHTSA
# When found in '''Audi''' 2.0T "FSI" Direct Injection engines, may also have DTCs [[P129F/004767]], P2293 and/or P0087.  See TSB 24-08-58  (TPI 2017356/2) for more information on testing and updated part numbers.
+
* When found in '''VW''' "FSI" Direct Injection engines (3.6L CDVC), may also have DTC P008B.  See TT 20-18-06TT (TPI 2053320) for information on loose pins at G410 or G410 replacement.
 +
** https://static.nhtsa.gov/odi/tsbs/2018/MC-10154081-9999.pdf  NHTSA
 +
* The G410 Fuel Pressure Sensor has a VW Warranty Extension in the US market due to premature failure.  Regardless of the vehicle brand, contact the local dealer with the full VIN to see if warranty extensions, recalls or RVU (required vehicle updates) apply.
 +
* When found in '''Audi''' 2.0T "FSI" Direct Injection engines, may also have DTCs [[P129F/004767]], P2293 and/or P0087.  See TSB 24-08-58  (TPI 2017356/2) for more information on testing and updated part numbers.
 
* When found on Direct Injection engines, such as the 2.0T, in combination with system too lean or similar faults indicating a vacuum leak address the cause of those first. Common fault codes are found [http://wiki.ross-tech.com/wiki/index.php/Special:Search?search=oil+cap&fulltext=Go here]
 
* When found on Direct Injection engines, such as the 2.0T, in combination with system too lean or similar faults indicating a vacuum leak address the cause of those first. Common fault codes are found [http://wiki.ross-tech.com/wiki/index.php/Special:Search?search=oil+cap&fulltext=Go here]
* When this fault is stored after all of the typical failure items have been replaced or tested verify the electric fuel pump and/or FPCM (Fuel Pump Control Module) is operating properly.  Low fuel pressure or volume may be the end result of a fuel supply problem including an incorrect fuel filter when the pressure regulator is integral.  The following video may be helpful:
+
* When this fault is stored after all of the typical failure items have been replaced or tested, verify the electric fuel pump and/or FPCM (Fuel Pump Control Module) is operating properly.  Low fuel pressure or volume may be the end result of a fuel supply problem including an incorrect fuel filter when the pressure regulator is integral.
 
+
** When found on FSI engines, MVB 106.2 shows the duty cycle of the lift pump, this value should be below 70%.  The higher the number, the more the lift pump has to run to maintain fuel pressure to the High Pressure Fuel Pump.
[http://www.youtube.com/watch?v=jThQVzYFbVo http://www.youtube.com/watch?v=jThQVzYFbVo]
+
** This video may be helpful:
[[Category:Fault Codes]]
 
 
 
  
 +
         [http://www.youtube.com/watch?v=jThQVzYFbVo http://www.youtube.com/watch?v=jThQVzYFbVo]
 +
* We have had several reports where the intank Lift Pump was replaced with an "OE" unit from a 3rd party supplier and still have issues.  Our suggestion is to purchase a proper OE unit from the dealer's parts department.
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Latest revision as of 15:33, 11 September 2023

P310B/012555 - Low Pressure Fuel regulation: Fuel Pressure Outside Specification

Possible Symptoms

  • MIL On
  • Reduced power

Possible Causes

  • Faulty Fuel Pressure Sensor (G410)
  • Wiring Harness for Fuel Pressure Sensor (G410)
  • Low Fuel Pressure
    • Weak Lift Pump
    • Restriction in Fuel Filter or Fuel Lines
  • Mechanical issue with High Pressure Fuel Pump
  • Replacement fuel filter not correct Bar rating (ex. 4.0 Bar vs 6.0 Bar)

Possible Solutions

  • Replace Fuel Pressure Sensor (G410)
  • Repair Damaged Wiring
  • Remove and inspect High Pressure Fuel Pump
  • Check Pressure Limiting Valve installed on the high pressure fuel rail when applicable

Special Notes

  • When found in VW "FSI" Direct Injection engines, may also have DTC P129F/004767. Can be caused by a faulty G410 sensor. See TSB 01-07-69 or 01-11-11 (TPI 2016182) for more information on testing and updated part numbers.
  • When found in VW "FSI" Direct Injection engines, may also have DTCs P129F, P008B, P129E, P008A, P2540 and/or P0087. See TSB 01-11-28 (TPI 2027458) for information which is similar to the first noted TSB.
  • When found in VW "FSI" Direct Injection engines (3.6L CDVC), may also have DTC P008B. See TT 20-18-06TT (TPI 2053320) for information on loose pins at G410 or G410 replacement.
  • The G410 Fuel Pressure Sensor has a VW Warranty Extension in the US market due to premature failure. Regardless of the vehicle brand, contact the local dealer with the full VIN to see if warranty extensions, recalls or RVU (required vehicle updates) apply.
  • When found in Audi 2.0T "FSI" Direct Injection engines, may also have DTCs P129F/004767, P2293 and/or P0087. See TSB 24-08-58 (TPI 2017356/2) for more information on testing and updated part numbers.
  • When found on Direct Injection engines, such as the 2.0T, in combination with system too lean or similar faults indicating a vacuum leak address the cause of those first. Common fault codes are found here
  • When this fault is stored after all of the typical failure items have been replaced or tested, verify the electric fuel pump and/or FPCM (Fuel Pump Control Module) is operating properly. Low fuel pressure or volume may be the end result of a fuel supply problem including an incorrect fuel filter when the pressure regulator is integral.
    • When found on FSI engines, MVB 106.2 shows the duty cycle of the lift pump, this value should be below 70%. The higher the number, the more the lift pump has to run to maintain fuel pressure to the High Pressure Fuel Pump.
    • This video may be helpful:

         http://www.youtube.com/watch?v=jThQVzYFbVo

  • We have had several reports where the intank Lift Pump was replaced with an "OE" unit from a 3rd party supplier and still have issues. Our suggestion is to purchase a proper OE unit from the dealer's parts department.