Readiness - APB Engine Code

From Ross-Tech Wiki

Manually Generating Readiness

Prerequisites:

  • Ignition ON and Engine ON.
  • No Fault Codes stored.
  • Transmission Oil Temperature must be between 60 °C and 90 °C.
    • If the procedure does not succeed in the first try, make sure the temperature is above 80 °C.
  • All driving and braking has to be done in partial load, avoid full throttle/braking!
  • Normally the adaptation needs to be carried out when:
    • Transmission Control Module has been recoded
    • Input Shaft has been replaced
    • Hydraulic Unit has been replaced
    • Transmission Control Module has been replaced
    • Transmission has been replaced


[Select]
[02 - Transmission]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Block 010 (in 1st Row)
Block 011 (in 2nd Row)
[Go!]
Check fields 2, specification is ADP OK.

  • Move the selector lever in position D and drive with partial load 20 m / 70 ft forward, then brake to standstill.
  • Hold the brake for 10 seconds.
  • Move the selector lever in position R and drive with partial load 20 m / 70 ft reverse, then brake to standstill.
  • Hold the brake for 10 seconds.

The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show ADP OK.
[Done, Go Back]
[Close Controller, Go Back - 06]