Difference between revisions of "User:Peter"
From Ross-Tech Wiki
| Line 1: | Line 1: | ||
| − | == | + | == Audi A5 (8T) Active/Dynamic Steering == |
| Line 11: | Line 11: | ||
* No fault codes other than [[01087 | 01087 - Basic Setting Not Performed]]'''<br> | * No fault codes other than [[01087 | 01087 - Basic Setting Not Performed]]'''<br> | ||
| − | * Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page: | + | * Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page: [[Audi A5 (8T) Steering Wheel Electronics#Basic Setting|Audi A4/A5 (8K/8T) Steering Angle Sensor (G85) Calibration]] |
| − | |||
| − | |||
| Line 20: | Line 18: | ||
<span style="color:#000000; background:#FFFF00"> '''- Continue Only after successfully completing the G85 basic settings -''' </span> | <span style="color:#000000; background:#FFFF00"> '''- Continue Only after successfully completing the G85 basic settings -''' </span> | ||
| + | |||
| + | *Leave the steering wheel in the straight ahead position during the next steps. | ||
Revision as of 10:34, 3 June 2013
Audi A5 (8T) Active/Dynamic Steering
1B-Active Steering
Prerequisites:
- Battery Voltage = 12.0 - 14.0 V
- No fault codes other than 01087 - Basic Setting Not Performed
- Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page: Audi A4/A5 (8K/8T) Steering Angle Sensor (G85) Calibration
- Continue Only after successfully completing the G85 basic settings -
- Leave the steering wheel in the straight ahead position during the next steps.
[Select]
[1B-Active Steering]
[Security Access - 16]
Enter 61378, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 101
[Go!]
[ON/OFF/Next]
- The results should be stored after a key cycle and fault code(s) should clear.
[Done, Go Back]
[Fault Codes - 02]
Check and clear fault codes.
[Close Controller, Go Back - 06]