User talk:Jef

[Select]
[15 - Airbags]
[Security Access - 16]
Enter the code shown in the pop-up balloon to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Select Resetting seat occupied recognition.
When applicable type the single digit 0 into the (reserved) box. If this is not present skip this step.
[Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
The reset has been performed.
[Done, Go Back]
[Fault Codes - 02] Faults should NOT be stored
[Close Controller, Go Back - 06]

Notes

• If you get a "Request Sequence Error" when performing the Resetting seat occupied recognition then check the following Advance Measuring Values:
  • IDE03871-ENG99733,Seat occupied recognition real part-Measured Value Capacitance
  • IDE03872-ENG99733,Seat occupied recognition imaginary part-Measured Value Capacitance
  • IDE03873-ENG99733,Seat occupied recognition compensated imaginary part-Measured Value Capacitance

If all of these value are 0 pF, then it is recommend to replace the pressure mat in the passenger seat.

• We had a repair facility report a Battery Disconnect was required when matching a brand new PODS module to the original Airbag controller when working on a 2011 Jetta Sedan.