VW Eos (1F/AH) Airbag VW8C

From Ross-Tech Wiki
Revision as of 13:29, 21 October 2011 by Dana (talk | contribs) (Created page with '__FORCETOC__ == Coding == VCDS will automatically tell you a suggested coding (HEX interface required) as explained here: [http://www.ross-tech.com/vag-com/cars/airbag-coding.h…')
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


Coding

VCDS will automatically tell you a suggested coding (HEX interface required) as explained here: VW Airbag module Coding on the Ross-Tech site. Registered users can contact us directly for assistance.

Adaptation

Used to deactivate individual airbag components (see repair manual for details).

Basic Setting

Seat Occupied Recognition Control Module (J706)

If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 30475, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]

Special Procedures

Seat Occupied Recognition Control Module (J706): Reset

If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.

Prerequisites:

  • Seat in normal position.
  • Seat must NOT be occupied during the whole procedure.
  • Seatbelt must NOT be plugged in.
  • No faults in the system.
  • Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).

[Select]
[15 - Airbags]
[Security Access - 16]
Enter 30475, to enable the adaptation.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]