VW Sharan (7M) Brake Electronics (MK25)

From Ross-Tech Wiki
Revision as of 22:33, 14 December 2014 by Peter (talk | contribs) (→‎Sensor for Steering Angle (G85))
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


  • ABS
    • 07177 = Standard
    • 06154 = Front-Wheel-Drive (FWD)
    • 06667 = All-Wheel-Drive (AWD)

Basic Setting

Sensor for Steering Angle (G85)


  • Start the vehicle.
  • Turn the steering wheel one turn to the right and one turn to the left (at least ± 15 ° each side).
  • Drive in a short distance straight line on a level surface at a speed not higher than 20 km/h.
  • If the steering wheel is straight during the test drive then stop the vehicle with the wheels pointed straight.
  • Ensure that the steering wheel is not moved again.
  • Keep the engine running and do not switch off the ignition.
  • System voltage at least 12.0 V.

[03 - Brake Electronics]
[Coding-II - 11]
Enter 40168, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 060
Activate the Basic Setting.
After a successful basic setting, field 2 should say "OK".
[Done, Go Back]
To make sure the basic setting was successful, check the sensor again.
[Measuring Blocks - 08]
Group 004
Check field 1, the value has to be between -1.5 and +1.5 °.
[Done, Go Back]
[Close Controller, Go Back - 06]