Peter: /* Additional Notes */

2022-09-26T18:28:38Z

Additional Notes

← Older revision		Revision as of 18:28, 26 September 2022
Line 26:		Line 26:
	** Fault may return immediately when cleared		** Fault may return immediately when cleared
	* Level Control System Air-Compressor may not operate after repairs, until the fault codes have been cleared in the Level Control controller (J197).		* Level Control System Air-Compressor may not operate after repairs, until the fault codes have been cleared in the Level Control controller (J197).
			* Once the fault code has cleared and the system is functioning correctly, the vehicle should level itself automatically. If needed, use the instructions found on this Ross-Tech forum post to raise/lower the vehicle. https://forums.ross-tech.com/index.php?threads/1996/

Peter: Created page with "== 01583 - Leak in System Detected == ==== Possible Symptoms ==== * Vehicle is Not Level * Level Control System Warning Message * Level Control System is not operational (..."

2022-09-26T17:04:35Z

Created page with "== 01583 - Leak in System Detected == ==== Possible Symptoms ==== * Vehicle is Not Level * Level Control System Warning Message * Level Control System is not operational (..."

New page

== 01583 - Leak in System Detected ==

==== Possible Symptoms ====

* Vehicle is Not Level
* Level Control System Warning Message
* Level Control System is not operational (Air-Compressor does not operate)

==== Possible Causes ====

* Air leak in system
* Level Control System Air-Compressor is Not functioning (pressure is 0.00 bar)
** Faulty Air-Compressor, fuse, relay, wiring, etc

==== Possible Solutions ====

* Inspect for leaks and repair as needed.
* Correct, repair or replace as needed faulty fuse(s), relay, wiring and/or Air-Compressor.
** Damaged (blown) fuse for the Air-Compressor could indicate the Air-Compressor is faulty and was drawing too much current.
** Verify the Air-Compressor relay has not been damaged/overheated due to excessive current (replace/repair as needed).

==== Additional Notes ====

* Fault code 01583 may set when the Level Control System has Not detected any change in Air Pressure (0.00 bar) when the Compressor is activated.
** Fault may return immediately when cleared
* Level Control System Air-Compressor may not operate after repairs, until the fault codes have been cleared in the Level Control controller (J197).

01583 - Revision history

Peter: /* Additional Notes */

Peter: Created page with "== 01583 - Leak in System Detected == ==== Possible Symptoms ==== * Vehicle is Not Level * Level Control System Warning Message * Level Control System is not operational (..."