Dana: Created page with 'FORCETOC == Coding == Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding. == Adaptation == =…'

2011-08-26T16:22:27Z

Created page with '__FORCETOC__ == Coding == Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding. == Adaptation == =…'

New page

__FORCETOC__
== Coding ==

Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding.

== Adaptation ==
=== Channel 010: Tourist Solution ===
When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.
* 0 = Disabled
* 1 = Enabled

== Security Access ==

Security Access codes will be shown in VCDS while connected to the vehicle.

== Basic Setting ==
=== Headlight Adjustment ===

'''[Select]''' 
'''[55 - Xenon Range]''' 
'''[Basic Settings - 04]''' 
Group 001 
'''[Go!]''' 
Activate the Basic Setting. 
'''[ON/OFF/Next]''' 
* The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
* Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
'''[ON/OFF/Next]''' 
The adjustment should now be learned. 
'''[Done, Go Back]''' 
Don't forget to check/clear fault codes afterwards. 
'''[Close Controller, Go Back - 06]'''

Headlight Aim Control Audi (8K) / (8T) - Revision history

Dana: Created page with '__FORCETOC__ == Coding == Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding. == Adaptation == =…'

Dana: Created page with 'FORCETOC == Coding == Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding. == Adaptation == =…'