VW Touareg (7P) Trunk Electronics: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
- 1. Security Access
- 2. Coding
-
3.
Basic Setting
- 3.1.3 Rear Lid relearn
Created page with "__FORCETOC__ This page applies to vehicles such as the Skoda Octavia (5E), Skoda Superb (3T), VW Sharan (7N) and VW Touareg with (7P) with Address-6D: Trunk Elect. Component..." |
No edit summary |
||
| Line 21: | Line 21: | ||
== Basic Setting == | == Basic Setting == | ||
=== Rear Lid relearn === | === Rear Lid relearn === | ||
Opening angle of tailgate | |||
'''<u>Prerequisites:</u>'''<br> | |||
* Rear Lid closed. | |||
* Transport mode NOT active. | |||
'''[Select]'''<br> | '''[Select]'''<br> | ||
''' [6D-Trunk Elect. | ''' [6D-Trunk Elect.]'''<br> | ||
'''[Basic Settings - 04]'''<br> | '''[Basic Settings - 04]'''<br> | ||
Select '''Adapt flap opening angle''' from the drop-down menu.<br> | Select '''Adapt flap opening angle''' from the drop-down menu.<br> | ||
'''[Go!]'''<br> | '''[Go!]'''<br> | ||
The rear lid Basic Settings will now begin and the rear lid will open.<br> | The rear lid Basic Settings will now begin and the rear lid will open.<br> | ||
''Finished Correctly (or similar) should be displayed.''<br> | ''Finished Correctly (or similar) should be displayed.''<br> | ||
*When the rear lid has stopped, close the rear lid using the E406 switch.<br> | |||
'''[Stop]'''<br> | '''[Stop]'''<br> | ||
'''[Done, Go Back]'''<br> | '''[Done, Go Back]'''<br> | ||
Revision as of 15:38, 8 March 2016
This page applies to vehicles such as the Skoda Octavia (5E), Skoda Superb (3T), VW Sharan (7N) and VW Touareg
with (7P) with Address-6D: Trunk Elect. Component: HDSG-Modul. This can be identified by evaluating the data
in the Auto-Scan:
Address 6D: Trunk Elect. (----) Labels: 7N0-959-107.clb Part No SW: 7P6 959 107 C HW: 7P6 959 107 Component: HDSG-Modul ASAM Dataset: EV_HeckkTouar 202142
Security Access
- Security Access codes will appear when connected to the control module with VCDS.
Coding
- Coding information is found using the Long Coding Helper while connected to the vehicle with VCDS.
- When replacing this module save the original coding and transfer it to the new module.
Basic Setting
Rear Lid relearn
Opening angle of tailgate
Prerequisites:
- Rear Lid closed.
- Transport mode NOT active.
[Select]
[6D-Trunk Elect.]
[Basic Settings - 04]
Select Adapt flap opening angle from the drop-down menu.
[Go!]
The rear lid Basic Settings will now begin and the rear lid will open.
Finished Correctly (or similar) should be displayed.
- When the rear lid has stopped, close the rear lid using the E406 switch.
[Stop]
[Done, Go Back]
- Check for fault codes, clear if needed.
[Close Controller, Go Back - 06]
- Check for proper operation
- Re-check for faults
Internal use reference: ST?ID=66024
No categories.