VW Touareg (7L) Trunk Electronics: Difference between revisions
          From Ross-Tech Wiki
          
          
      
      
      
      Table Of Contents
- 1. Security Access
 - 2. Coding
 - 
          
          3.
          Basic Setting
          
- 3.1.3 Rear Lid relearn
 
 
No edit summary  | 
				No edit summary  | 
				||
| Line 17: | Line 17: | ||
=== Rear Lid relearn ===  | === Rear Lid relearn ===  | ||
'''<u>Prerequisites:</u>'''<br>  | '''<u>Prerequisites:</u>'''<br>  | ||
* Rear Lid closed.  | * Rear Lid closed  | ||
* No rear lid obstructions or damage to the vehicle  | |||
* Battery voltage at least 12.0V  | |||
* Vehicle is on a flat level surface   | |||
'''[Select]'''<br>  | '''[Select]'''<br>  | ||
Revision as of 16:54, 8 March 2016
This page applies to Address-6D: Trunk Elect.in the VW Touareg (7L6) with Component: J605 HECKKLAPPE. This can be identified by evaluating the data in the Auto-Scan:
Address 6D: Trunk Elect. Labels: None Part No SW: 7L6 959 107 B HW: 7L6 959 107 B Component: J605 HECKKLAPPE 1310
Security Access
- Security Access codes will appear when connected to the control module with VCDS.
 
Coding
- This control module is Short coded.
 - When replacing this module save the original coding and transfer it to the new module.
 
Basic Setting
Rear Lid relearn
Prerequisites:
- Rear Lid closed
 - No rear lid obstructions or damage to the vehicle
 - Battery voltage at least 12.0V
 - Vehicle is on a flat level surface
 
[Select]
 [6D-Trunk Elect.]
 [Security Access - 16]
Enter 59107
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
The rear lid Basic Settings will now begin and the rear lid will now open. If the lid does not open use the [On/Off/Next] button.
[Done, Go Back]
- When the rear lid has stopped, close the rear lid.
 - Check for fault codes, clear if needed.
 
[Close Controller, Go Back - 06]
- Check for proper operation
 - Re-check for faults
 
Internal use references: ST?ID=59047 -and- ST?ID=37245
No categories.