P00AF/000175: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
-
1.
000175/P00AF - Actuator Module for Turbocharger 1: Stuck
- 1.1.1 Possible Symptoms
- 1.2.1 Possible Causes
- 1.3.1 Possible Solutions
- 1.4.1 Special Notes
No edit summary |
|||
| Line 10: | Line 10: | ||
* Defective N75 | * Defective N75 | ||
* N75 connector plugged into the wrong 2 wire component. Check wiring diagram to confirm | |||
* Vacuum leak or low vacuum | * Vacuum leak or low vacuum | ||
* VNT sticking or seized | * VNT sticking or seized | ||
| Line 17: | Line 18: | ||
*Verify N75 is working to design, use Output Testing | *Verify N75 is working to design, use Output Testing | ||
* Verify the N75 connector plugged into N75 per the factory level wiring diagram | |||
*Verify vacuum lines are good, check engine vacuum at idle | *Verify vacuum lines are good, check engine vacuum at idle | ||
*Test VNT and G581, apply vacuum to VNT and watch MVB 120.4 | *Test VNT and G581, apply vacuum to VNT and watch MVB 120.4 | ||
Revision as of 15:28, 9 June 2015
000175/P00AF - Actuator Module for Turbocharger 1: Stuck
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
- Glow Plug light flashing
- Reduced engine performance
Possible Causes
- Defective N75
- N75 connector plugged into the wrong 2 wire component. Check wiring diagram to confirm
- Vacuum leak or low vacuum
- VNT sticking or seized
- G581 sensor
Possible Solutions
- Verify N75 is working to design, use Output Testing
- Verify the N75 connector plugged into N75 per the factory level wiring diagram
- Verify vacuum lines are good, check engine vacuum at idle
- Test VNT and G581, apply vacuum to VNT and watch MVB 120.4
- Engine off, no vacuum 120.4 should read about 3.5V
- Engine Off, apply 17 Inches of mercury, 120.4 should drop to about .7V
- Engine at idle, 120.4 should read about 7.V
- If 120.4 voltage doesn't alter, VNT may be seized or G581 failed
Special Notes
- On some TDI engines, the Vacuum Diaphragm/G581 unit can be purchased as a separate part from dealer.
- 2.0L CR TDI owners may find this thread helpful: