00515

From Ross-Tech Wiki

Jump to: navigation, search

Contents

00515 - Camshaft Position (Hall) Sensor (G40)

00515 - Camshaft Position (Hall) Sensor (G40): No Signal

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Engine Control Module

Special Notes

  • Some older engines store this code as long as the engine is not running, if in doubt read fault codes with the engine running again.


00515 - Camshaft Position (Hall) Sensor (G40): Implausible Signal

Possible Causes

  • Camshaft Timing Out of Specification
  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) faulty
  • Engine Control Module faulty

Possible Solutions

  • Check Camshaft Timing
  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Engine Control Module


00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to Plus

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) Installation faulty
  • Camshaft Timing Out of Specification
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
  • Check Camshaft Timing
  • Check/Replace Engine Control Module


00515 - Camshaft Position (Hall) Sensor (G40): Short to Ground

Possible Symptoms

  • Power Loss
  • Emissions not OK
  • High Fuel Consumption

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)



Unless otherwise noted, all content on this site is Copyright © 2000-2010 by Ross-Tech LLC. All rights reserved.
"VCDS" is a Registered Trademark of Ross-Tech, LLC.
Ross-Tech is not affiliated with the Volkswagen Group in any way.