From Ross-Tech Wiki

01739 - Crash Sensor for Front Airbag: Passenger Side (G284)

Possible Symptoms

  • Airbag Light is on
  • MIL is on

Possible Causes

  • Wiring and/or connections faulty
  • G284 is faulty

Possible Solutions

  • Check wiring and connections for G284
  • If connections are ok, change passenger side crash sensor (G284) with drivers side sensor (G283). If the fault change also, you found a faulty sensor. Replace it
  • If changing G283 with G284 does not change the fault, then check wiring between G284 and Airbag Control Unit.
    • If someone repaired or replaced the 2 wire connector at the crash sensor and reversed (swapped) the wiring the DTC may show: Open or Short to Plus - MIL ON. The wiring diagram for the vehicle in question will add clarity.

Special Notes

  • When found in the NAR (North American Region) New Beetle and New Beetle Convertible models see if the R6 / 69H1 Safety Recall was completed. The TSB involves replacing both crash sensors (G284 & G283) when the old / early production sensors are instated.
    • The common fault codes are 01739 and / or 01738