17755/P1347/004935

From Ross-Tech Wiki

Jump to: navigation, search

Contents

17755/P1347/004935 - Camshaft Position Sensor 2 (G163) / Engine Speed Sensor (G28): Incor. Correl.

Possible Causes

  • Timing Belt/Chain incorrectly installed
    • Timing Chain probably lengthened
  • Camshaft Position Sensor 2 (G163) faulty
  • Engine Speed Sensor (G28) faulty

Possible Solutions

  • Check Timing Belt/Chain installation
    • Use Measuring Value Blocks (MVB) to Check Timing Chain
  • Check/Replace Camshaft Position Sensor 2 (G163)
  • Check/Replace Engine Speed Sensor (G28)

Special Notes

  • When found in VR6 4 Valve (BDF, BJS, BAA,) engines in conjunction with 17748 please see Technical Bulletin 15-07-03. The previous Technical Bulletin number was 15-04-01.
  • When found in a 30-valve V6 gasoline Audi engine (such as EPB or BEL), DTC 17748 may be stored as well. If both of these codes are displayed simultaneously, and the codes only appear after the motor is revved above 1800RPM, then the issue is likely that the cam chain tensioners were installed on the incorrect heads (drivers' tensioner on passenger head, etc).
  • On engines with chain driven intake camshaft(s), but belt driven exhaust camshaft(s), verify the number of chain roller links between the intake and exhaust camshafts is correct. Click on thumbnail to enlarge:

Cam timing chains.gif




Unless otherwise noted, all content on this site is Copyright © 2000-2010 by Ross-Tech LLC. All rights reserved.
"VCDS" is a Registered Trademark of Ross-Tech, LLC.
Ross-Tech is not affiliated with the Volkswagen Group in any way.