Audi A4 (8D) Central Locking

Special Procedures

Remote Control Clearing

Clearing of all memory potions, e.g. in case of a lost key.

Prerequisites:
Ignition ON.

• Mechanically lock the car from the outside using the driver-side lock.
• Press the remote control "unlock" button five times at one second intervals.
• Wait 6 seconds, then press remote control "unlock" button one more time to confirm this clearing procedure.

All memory positions are now erased, central locking should not be operational via remote control.

---

Remote Control Synchronization

• Press any button on remote control.
  

If vehicle does not respond by locking or unlocking:

• Lock and unlock vehicle within 30 seconds using driver-side lock.
• Now check function of synchronized remote control.

---

Remote Control Matching

Prerequisites:
Ignition ON.
Two vehicle keys present.

[Select]
[35 - Central Locking]
[Measuring Blocks - 08]
Group 003
[Go!]
The value in field 2 shows how many remotes have been matched and in which memory positions (for example, "0001" indicates 1 transmitter in position 1).
[Done, Go Back]
[Close Controller, Go Back - 06]

• Leave the key in the ignition ON
• Lock the car from outside using the new, unmatched key in the driver-side door lock.
• Press the UNLOCK button on the new key within 5 seconds often enough to reach next memory position (so, if the value in field 2 was 0001, you should press the new key's unlock button twice, to put the new key in memory position 2).
  • The car may give you some sort of acknowledgment as the button is pressed (lights flash, horn beep, etc.)
• Wait 5 seconds and press the unlock button on the new key to unlock the door.
• Turn the ignition key to OFF and remove the old key.
• Press LOCK and UNLOCK with the new key.
• Insert the new key in the ignition and turn to the ON position (do not start car).
  
  

[Select]
[35 - Central Locking]
[Measuring Blocks - 08]
Group 003
[Go!]
The value in field 2 should now indicate 0011 in the example used, showing the old key still matched in position 1 and the new key matched in position 2.

Make sure that new keys are always coded into free memory positions (where there is a zero in Group 003, field 2). If occupied positions (distinguishable by a "1") are used, the transmitter previously coded to this position will no longer work.
[Done, Go Back]
[Close Controller, Go Back - 06]