Bentley Continental (3W) Rear Spoiler
From Ross-Tech Wiki
Basic Setting
Special Procedures
J223-Rear spoiler activation
Perform the following when fault code '01507-Initialization Not Successful' is present.
Key on, engine running.
- Press the Rear Spoiler 'up' button, the rear spoiler will now deploy, then should retract in four steps.
or
- Drive the vehicle greater than 25km/h for a short distance, the code should clear or can be cleared and rear spoiler operation should be normal.
Notes:
If the code clears and the spoiler functions correctly, the initialization is completed.
If the Initialization fails, you can disconnect the J223 controller for 10-15 minutes, then repeat the above. And check the rear spoiler for any mechanical concerns, such as blockage or damage.