VW Golf (1K) Brake Electronics (MK70)

From Ross-Tech Wiki

Coding

ABS (MK70)

  • Model:
    • +0000001 = Audi A3 (8P) / Seat Altea (5P) / Seat Leon (1P) / VW Golf/Jetta (1K) / Skoda Octavia (1Z)
    • +0000065 = VW Touran (1T)
    • +0000082 = VW Caddy (2K)
    • +0000097 = VW Eos (1F)
  • Suspension:
    • +0000640 = Standard Suspension
  • Tire Pressure Monitoring (TPMS):
    • +0000000 = with ABS based Tire Pressure Monitoring (PR-7K1/7K6)
    • +0016384 = without ABS based Tire Pressure Monitoring (PR-7K0/7K4/7K8)

Notes: See production codes on car data plate. Coding is the sum of the individual options.

Basic Setting

Sensor for Steering Angle (G85)

For Continental/Teves Brake Electronics MK70, the basic setting needs to be carried out in the Steering Assist control module.


Tire Pressure Monitoring System Reset

Prerequisites:

  • Ignition ON

[Select]
[03 - Brake Electronics]
[Basic Settings - 04]
Group 042
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
[Done, Go Back]
[Close Controller, Go Back - 06]

  • The Tire Pressure Monitoring Lamp (K220) should blink.
  • Now check the Tire Pressure and correct it if necessary.
  • Press and Hold the Tire Pressure Monitoring Button (E492) AND the ASR/ESP Button (E256) for 2 Seconds.
  • A short Tone should sound after pressing/holding these buttons for 2 Seconds and the blinking should change to a permanent lit Tire Pressure Monitoring Lamp (K220).
  • The Reset is now done and as soon as you let the buttons go the Tire Pressure Monitoring Lamp (K220) should go OFF.