VW Touareg (7L) Heating/Air Conditioning

Coding

• 00xxx?0: Glass Type
  • 2 = Standard Glass (Clear Glass)
  • 3 = Thermal Protection Glass (Insulated/Acoustic Glass)
• 00xx?x0: Roof
  • 0 = Solar Roof not installed & Anti-Whistle Measures inactive
  • 1 = Anti-Whistle Measures active (only older Climate Control Units)
  • 2 = Solar Roof installed
  • 3 = Solar Roof not installed & Anti-Whistle Measures active (4-Zone Climatronic)
  • 4 = Solar Roof installed & Anti-Whistle Measures active (4-Zone Climatronic)
  • 5 = Solar Roof not installed & Anti-Whistle Measures inactive & Without Acoustic Package
  • 6 = Anti-Whistle Measures active (only older Climate Control Units) & Without Acoustic Package
  • 7 = Solar Roof installed & Without Acoustic Package
  • 8 = Solar Roof not installed & Anti-Whistle Measures active (4-Zone Climatronic) & Without Acoustic Package
  • 9 = Solar Roof installed & Anti-Whistle Measures active (4-Zone Climatronic) & Without Acoustic Package
• 00x?xx0: Refrigerant Loss Recognition
  • 0 = Refrigerant Temperature Sensor installed (Recognition activated)
  • 1 = Refrigerant Temperature Sensor not installed (Recognition deactivated)
  • 2 = Refrigerant Temperature Sensor installed (Recognition activated / V6 FSI Engine)
• 00?xxx0: Options
  • +1 = Climate Control Activation Delay (140 ms) active
  • +2 = Anti-Fog Measures active (Hot Country/"Florida" Coding)

Basic Setting

Normal (Potentiometer & Flap Adaptation)

Prerequisites:

• Potentiometer / Flap replyed
• OR Climatronic Control Module (J255) replaced
• OR Climatronic Control Module (J255) recoded

[Select]
[08 - Heating/Air Conditioning]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The basic setting takes approximately 25 seconds.
[Done, Go Back]
[Close Controller, Go Back - 06]

Service Position

Notes:

• Has to be performed before ANY Actuators/Motors are being removed.
• While in Service Position the Display reads SF (German for "Servicefall").
• Make sure to have the Ignition OFF while working on the Actuators/Motors.
• Once all work has been done, switch ON the Ignition and perform the normal Basic Setting (Potentiometer & Flap Adaptation).

[Select]
[08 - Heating/Air Conditioning]
[Basic Settings - 04]
Group 002
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The Display should read SFnow.
[Done, Go Back]
[Close Controller, Go Back - 06]