|
|
| Line 27: |
Line 27: |
| | * While adapting each key, make sure to place the other keys away from the ignition lock (reader coil). ''The passenger seat is an adequate place.'' | | * While adapting each key, make sure to place the other keys away from the ignition lock (reader coil). ''The passenger seat is an adequate place.'' |
| | * Battery voltage at least 12.5 V.<br> | | * Battery voltage at least 12.5 V.<br> |
| − |
| |
| − |
| |
| − | '''[Select]'''<br>
| |
| − | '''[17 - Instruments]'''<br>
| |
| − | ''Write down the 14 digit Immobilizer ID number from the "Extra" field''<br>
| |
| − | '''[Meas. Blocks - 08]'''<br>
| |
| − | Select Block 002.<br>
| |
| − | '''[Go!]'''<br>
| |
| − | ''The value in field 3 must be 1. If value is not 1, the key is not capable of being adapted to Immobilizer.''<br>
| |
| − | ''You can check each key in this manner.''
| |
| − |
| |
| − | 1.
| |
| − |
| |
| − | [Select]
| |
| − | [17 - Instruments]
| |
| − | Write down the 14 digit Immobilizer ID number from the "Extra" field
| |
| − |
| |
| − | 2.
| |
| − |
| |
| − | Take that ID number to your dealer and request your seven-digit SKC, along with the workshop code and importer number (all this information can be found in the upper-right corner of the Administration screen of the dealer's VAS 5051). Additional information about how to find the WSC and Importer Number can be found here.
| |
| − |
| |
| − | 3.
| |
| − |
| |
| − | Measure the car's battery voltage, it must be 12.5 V or higher.
| |
| − |
| |
| − | 4.
| |
| − |
| |
| − | You can check to make sure a key has the correct electronics in it so that it can be matched to the Immobilizer by:
| |
| − | [Select]
| |
| − | [17 - Instruments]
| |
| − | [Meas. Blocks - 08]
| |
| − | Group 022
| |
| − | [Go!]
| |
| − | The value in field 3 must be 1. If value is not 1, the key is not capable of being adapted to Immobilizer. You can check each key in this manner.
| |
| − |
| |
| − | 5.
| |
| − |
| |
| − | [Select]
| |
| − | [17 - Instruments]
| |
| − | [Meas. Blocks - 08]
| |
| − | Group 024
| |
| − | [Go!]
| |
| − | Any numbers displayed in fields 1-4 represent the time in minutes that must be counted down before the Immobilizer is unlocked. If the fields are all zero, skip to step 6. If the Immobilizer is locked:
| |
| − | [Done, Go Back]
| |
| − | [Close Controller, Go Back - 06]
| |
| − | Do not switch off the ignition! Allow the car to sit for AT LEAST the number of minutes that were indicated by the display in Group 024
| |
| − |
| |
| − | 6.
| |
| − |
| |
| − | [Select]
| |
| − | [17 - Instruments]
| |
| − | [Meas. Blocks - 08]
| |
| − | Group 024
| |
| − | [Go!]
| |
| − | Make sure all fields are zero.
| |
| − | [Done, Go Back]
| |
| − |
| |
| − | 7.
| |
| − |
| |
| − | [Login - 11]
| |
| − | [Use 7-digit PIN/SKC]
| |
| − | Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
| |
| − | [OK]
| |
| − |
| |
| − | 8.
| |
| − |
| |
| − | VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".
| |
| − | [Do It!]
| |
| − |
| |
| − | 9.
| |
| − |
| |
| − | [Adaptation - 10]
| |
| − | Enter 21 in "Channel Number"
| |
| − | [Read]
| |
| − | The "Stored Value" is the number of keys currently matched.
| |
| − | Enter "new value" of 0
| |
| − | [Save]
| |
| − | This clears out the old key-matchings.
| |
| − | Enter a "new value" corresponding to the total number of keys to be matched, including any existing keys
| |
| − | [Save]
| |
| − |
| |
| − | 10.
| |
| − |
| |
| − | [Done, Go Back]
| |
| − | [Close Controller, Go Back - 06]
| |
| − | Switch ignition off and remove key
| |
| − |
| |
| − | 11.
| |
| − |
| |
| − | Insert next key to ignition and switch ignition on again
| |
| − | The warning light for the Immobilizer will light up for ~2 seconds, then go out
| |
| − | Switch ignition off and remove key
| |
| − |
| |
| − | 12.
| |
| − |
| |
| − | Repeat step 11 with each key until all keys have been matched.
| |
| − |
| |
| − |
| |
| − |
| |
| − | '''[Select]'''<br>
| |
| − | '''[25 - Immobilizer]'''<br>
| |
| − | '''[Meas. Blocks - 08]'''<br>
| |
| − | Select Block 002.<br>
| |
| − | '''[Go!]'''<br>
| |
| − | ''The value in field 3 must be 1. If value is not 1, the key is not capable of being adapted to Immobilizer.''<br>
| |
| − | ''You can check each key in this manner.''
| |
| − |
| |
| − |
| |
| − | Select Block 003.<br>
| |
| − | '''[Go!]'''<br>
| |
| − | ''Make sure the shown lock times in field 1, 2 and 3 are '''0''' (each field represents a time in minutes).''<br>
| |
| − | * ''If the lock times are NOT '''0''':''
| |
| − | ** ''Do NOT switch off the ignition!''
| |
| − | ** ''Allow the car to sit for AT LEAST the number of minutes that were indicated by the fields 1-3.''
| |
| − | '''[Done, Go Back]'''<br>
| |
| − |
| |
| − |
| |
| − | '''[Security Access - 16]'''<br>
| |
| − | ''There are 2 possibilities how to enter a PIN, choose the one that applies for you.''
| |
| − | * '''4-digit PIN'''
| |
| − | ** Enter zero followed by the 4-digit PIN. ''For example, if your PIN is 1234, enter 01234.''
| |
| − | * '''7-digit PIN'''
| |
| − | ** '''[Use 7-digit PIN/SKC]'''
| |
| − | ** Enter the 7-digit PIN, Date on which the PIN was generated by the dealer, along with the Workshop Code (WSC) and the Importer number of the dealer that generated the code.
| |
| − | ** '''[OK]'''
| |
| − | ** VAG-COM will validate the data you have entered and return you to the Login screen, where the Login Code will show as "XXXXX".
| |
| − | '''[Do it!]'''<br>
| |
| − |
| |
| − |
| |
| − | '''[Adaptation - 10]'''<br>
| |
| − | Enter 001 in "Channel Number".<br>
| |
| − | '''[Read]'''<br>
| |
| − | ''The "Stored Value" is the number of keys currently matched.''<br>
| |
| − | Enter a "new value" corresponding to the total number of keys to be matched, including any existing keys.<br>
| |
| − | ''The old keys are automatically beeing cleared.''<br>
| |
| − | '''[Save]'''<br>
| |
| − | '''[Done, Go Back]'''
| |
| − | '''[Close Controller, Go Back - 06]'''
| |
| − |
| |
| − |
| |
| − | * ''Repeat the following steps until all keys have been matched:''<br>
| |
| − | **''Switch ignition off and remove key.''<br>
| |
| − | **''Insert next key to ignition and switch ignition on again.''<br>
| |
| − | **''The warning light for the Immobilizer will light up for ~2 seconds, then go out Switch ignition off and remove key.''<br>
| |
| − |
| |
| − | '''Note:''' ''The above steps after saving the adaptation, should not exceed 60 seconds!''
| |