Readiness - APB Engine Code

Manually Generating Readiness

• Ignition ON and Engine OFF
  

Reading and clearing fault codes

[Select]
[01 - Engine]
[Fault Codes - 02]
[Clear Codes -05]
[Done, Go Back]

Throttle Body Alignment

[Measuring Blocks - 08]
Select group 060
[Go]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. Leave it in Basic Settings until the display reads ADP OK.
[Switch to Meas. Blocks]

Transmission kickdown (applies to Auto Trans vehicles only!)

Select group 063
[Go]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. Leave it in Basic Settings until the display reads ADP OK.
[Switch to Meas. Blocks]

• Ignition ON and Engine ON at idle
  

Fuel leakage test

Select group 063
[Go]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. Leave it in Basic Settings until the display reads ADP OK.
[Switch to Meas. Blocks]

Channel 000
[Read]
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Block 010 (in 1st Row)
Block 011 (in 2nd Row)
[Go!]
Check fields 2, specification is ADP OK.

• Move the selector lever in position D and drive with partial load 20 m / 70 ft forward, then brake to standstill.
• Hold the brake for 10 seconds.
• Move the selector lever in position R and drive with partial load 20 m / 70 ft reverse, then brake to standstill.
• Hold the brake for 10 seconds.

The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show ADP OK.
[Done, Go Back]
[Close Controller, Go Back - 06]