Difference between revisions of "02830"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
|||
| Line 22: | Line 22: | ||
* When found in [[VW Passat (3C) CAN-Gateway|VW Passat (3C): CAN-Gateway]], check Measuring Value Block (MVB) 002.3 while cycling the Ignition. It should change between active and passive. | * When found in [[VW Passat (3C) CAN-Gateway|VW Passat (3C): CAN-Gateway]], check Measuring Value Block (MVB) 002.3 while cycling the Ignition. It should change between active and passive. | ||
| + | * When found in the [[VW Passat (3C) CAN-Gateway|VW Passat (3C): CAN-Gateway]] after module replacement, see if address 4F-Centr. Electr. II is installed. If it is, that may be a virtual address in the new CAN Gateway and therefore need to be coded. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 14:49, 18 January 2013
02830 - Control Circuit for CAN Isolator for Driver Assistance Systems
02830 - Control Circuit for CAN Isolator for Driver Assistance Systems: Electrical Fault in Circuit
Possible Causes
- Supply Voltage insufficient
- Control Module Coding incorrect
- Incorrect Control Module installed
Possible Solutions
- Check Control Module Power Supply
- Check Control Module Coding (see Vehicle specific Diagnostic Procedures).
- Check CAN-Databus Powertrain Cut-Off Relay (J788)
- Check Measuring Value Blocks (MVB)
- Perform Output Test and check for an audible noise while the Relay is being actuated.
- Check if Control Module (Part Number) fits the Car's Equipment
Special Notes
- When found in VW Passat (3C): CAN-Gateway, check Measuring Value Block (MVB) 002.3 while cycling the Ignition. It should change between active and passive.
- When found in the VW Passat (3C): CAN-Gateway after module replacement, see if address 4F-Centr. Electr. II is installed. If it is, that may be a virtual address in the new CAN Gateway and therefore need to be coded.