Audi CAN Gateway Battery Coding (8T/8K/8R+): Difference between revisions

From Ross-Tech Wiki
Dana (talk | contribs)
1,749 edits
Created page with "__FORCETOC__ '''General Information:''' Most 2009+ Audi A4 and newer models do NOT use a separate 61-Battery Manager. In these cases battery management is a slave (subsyste..."
 
Dana (talk | contribs)
1,749 edits
Replaced content with "__FORCETOC__ The information that was on this page moved to the Battery Replacement page."
 
(6 intermediate revisions by 3 users not shown)
Line 1: Line 1:
__FORCETOC__
__FORCETOC__
 
The information that was on this page moved to the [[Battery Replacement]] page.
'''General Information:'''  Most 2009+ Audi A4 and newer models do NOT use a separate 61-Battery Manager.  In these cases battery management is a slave (subsystem) under the 19-CAN-Gateway control module. This page covers those 8T/8K/8R and newer models using a CAN Protocol 9-CAN-Gateway control module.<br>
<br>
If the vehicle in question uses a diagnostic capable 61-Battery Regulation controller this page ''should'' apply instead:
* [[Audi A8 (4E) Battery Replacement|61-Battery Regulation]]<br>
<br>
----
 
=== Long Adaptation ===
 
Installation of a new battery requires the use of the [http://www.ross-tech.com/vcds/tour/adaptation_screen.html#long Long Adaptation] function under 19-CAN-Gateway control module. Follow the onscreen instructions to enter the Part Number, Vendor, and Serial Number all as one long new value.
 
 
=== Special Notes ===
 
 
 
 
 
[[Category:Subsystems]]

Latest revision as of 18:56, 10 May 2016

The information that was on this page moved to the Battery Replacement page.

Retrieved from "https://wiki.ross-tech.com/wiki/index.php?title=Audi_CAN_Gateway_Battery_Coding_(8T/8K/8R%2B)&oldid=8043"
Contact Privacy Accessibility