|
|
| (7 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| | __FORCETOC__ | | __FORCETOC__ |
| − | '''This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.'''
| |
| | | | |
| − | ''The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself. Make sure to refer to the factory repair manual in order to fulfill all additional prerequisites.''
| + | The information that was on this page moved to the [[Battery Replacement]] page. |
| − | | |
| − | '''[Select]'''<br>
| |
| − | '''[61 - Battery Regulation]'''<br>
| |
| − | '''[Coding - 07]'''<br>
| |
| − | Use the pull down menu to select the battery (slave) listed as #1.<br>
| |
| − | '''[http://www.ross-tech.com/vcds/tour/recode_screen.html#battery [Battery Coding]]'''<br>
| |
| − | * Enter the new Battery Part Number (10 or 11 digits).
| |
| − | * Enter the new Battery Serial Number (10 digits).
| |
| − | * Select the new Battery Vendor.
| |
| − | '''[OK]'''<br>
| |
| − | '''[Do it!]'''<br>
| |
| − | '''[Close Controller, Go Back - 06]'''<br>
| |
| − | | |
| − | Your new Battery should now be coded and the Battery Control Module should be aware of the new Battery.<br>
| |
| − | | |
| − | | |
| − | '''Note''': The 10 digit serial number may be preceded by the Battery Vendor Code, for instance VA0 See examples below:
| |
| − | | |
| − | {| class="wikitable" border="0" width="450"
| |
| − | |-
| |
| − | !colspan="14" style="background:white"| Click on thumbnail image to enlarge.
| |
| − | |-
| |
| − | | [[File:Battery serial number.jpg|200px|center|caption]]
| |
| − | |-
| |
| − | | If the code is VA0310314E04G then drop the VA0 and just enter 310314E04G as the Serial Number.
| |
| − | |}
| |
| − | | |
| − | Sometimes the battery part number sticker can cover up the white sticker with the serial number.
| |
| − | | |
| − | <br>
| |
| − | If you are encountering difficulty communicating with modules during or after the coding process make sure the battery charger is connected as per repair manual. Click the photo to enlarge.
| |
| − | | |
| − | [[File:A8 charger hookup.jpg|left|200px|caption]]
| |