Difference between revisions of "01318"
From Ross-Tech Wiki
| (One intermediate revision by one other user not shown) | |||
| Line 56: | Line 56: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * When found on 2.5l V6 TDI, | + | * When found on 2.5l V6 TDI, turn the key OFF, disconnect the car's battery for a few minutes, then re-connect it and try clearing faults again. See TPI # 962201 |
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 15:58, 9 June 2023
01318 - Control Module for Injection Pump (J399)
01318 - Control Module for Injection Pump (J399): Signal Outside Specifications
01318 - Control Module for Injection Pump (J399): Implausible Signal
01318 - Control Module for Injection Pump (J399): Faulty
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
- Limp Mode & Reduced Power/Output
- Emergency/Safety Shut-Off
Possible Causes
- Injection Pump (J399) faulty
Possible Solutions
- Check/Replace Injection Pump (J399)
01318 - Control Module for Injection Pump (J399): No Communications
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
Possible Causes
- Wiring and/or Connector(s) from/to Injection Pump (J399) faulty
- Injection Pump (J399) faulty
Possible Solutions
- Check Wiring and/or Connector(s) from/to Injection Pump (J399)
- Check Communication to Injection Pump (J399)
- See Measuring Value Block (MVB) 018
- Check/Replace Injection Pump (J399)
Special Notes
- When found on 2.5l V6 TDI, has a Compression Test been performed? This code may be stored in Combination with a Compression Test even though the Communication is OK. Under these Circumstances this Fault Code should be cleared.
01318 - Control Module for Injection Pump (J399): No Elaboration Available
Possible Symptoms
- Malfunction Indicator Light (MIL) ON
Possible Causes
- Control Module Software Issue
Special Notes
- When found on 2.5l V6 TDI, turn the key OFF, disconnect the car's battery for a few minutes, then re-connect it and try clearing faults again. See TPI # 962201