|
|
| (21 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | === Electronic Damping Control J250 - Basic Settings === | + | = WARNING: RESTRICTED ACCESS = |
| | | | |
| | + | Your attempt to access this page is considered UNAUTHORIZED! |
| | + | '''ERROR 401: UNAUTHORIZED''' |
| | | | |
| − | '''<u>Prerequisites:</u>'''<br>
| + | Your IP address has been logged. |
| − | * Battery Voltage = 12.0 - 14.0 V'''<br>
| |
| − | * No fault codes other than [[01087 | 01087 - Basic Setting Not Performed]]'''<br>
| |
| − | * Vehicle is lifted off the ground, on a suitable vehicle lift'''<br>
| |
| − | | |
| − | | |
| − | '''[Select]'''<br>
| |
| − | '''[14 - Susp. Elect]'''<br>
| |
| − | '''[Meas. Blocks - 08]'''<br>
| |
| − | Note: The values stored in the Measuring Value Blocks below are the Minimum and Maximum sensor values.'''<br>
| |
| − | * Group-054 Field-1 = G78 - Min value'''<br>
| |
| − | * Group-054 Field-2 = G78 - Max value'''<br>
| |
| − | <br>
| |
| − | * Group-055 Field-1 = G289 - Min value'''<br>
| |
| − | * Group-055 Field-2 = G289 - Max value'''<br>
| |
| − | <br>
| |
| − | '''Look at:'''<br>
| |
| − | '''Group-003 - Field-1,2,3 - Actual Sensor values'''<br>
| |
| − | * If the values are with in the range of the Min - Max stored values from MVBs 054 and 055 then Basic settings can be performed, if not inspect suspension or sensors.'''<br>
| |
| − | <br>
| |
| − | '''[Security Access - 16]'''<br>
| |
| − | Enter 31564, to enable the basic setting.'''<br>
| |
| − | '''[Do it!]'''<br>
| |
| − | '''[Basic Settings - 04]'''<br>
| |
| − | Group 001<br>
| |
| − | '''[Go!]'''<br>
| |
| − | <br>
| |
| − | The New values should be displayed.'''<br>
| |
| − | * To check the learned values, check Measuring Value Group-008.'''<br>
| |
| − | '''[Meas. Blocks - 08]'''<br>
| |
| − | Group 008<br>
| |
| − | '''[Go!]'''<br>
| |
| − | The values displayed should be the learned values as displayed in the Basic Settings window.'''<br>
| |